Chapters0/30 ▾
Study guide · Chapter 6 of 7
Rigging Hardware & Lifting Devices Study Guide — Rigger Level I (NCCCO)
22 free practice questions
Hardware questions are about using shackles, hooks, eyebolts, turnbuckles, hoists and below-the-hook devices the way they were designed to be loaded. Several items need arithmetic, and the trick is reading each chart's heading: some tables state a percent reduction and others state the percent that remains, and mixing the two up is the usual mistake. The ratings always come from the manufacturer of the piece in your hand.
Key takeaways
- Shackles are loaded in the bow, with multiple legs at an included angle of no more than 120 degrees.
- Read each chart's heading: a 30 percent shackle reduction leaves 70 percent, while a 30 percent eyebolt rating is all that remains.
- Only shoulder eyebolts, seated flush with at least 1.5 diameters of thread in steel, may take an angled pull.
- If a lever hoist will not move the load with normal effort, stop and find out why; never add a cheater bar.
- A jack lifts but does not hold: the raised load is blocked and cribbed before anyone reaches under it.
Lessons in this chapter
4 short lessons · 4 min read
- 1Using shackles correctly1 min
- 2Hooks, eyebolts and swivel hoist rings1 min
- 3Turnbuckles, swivels, blocks and hoists1 min
- 4Clamps, beams, gantries, rollers and jacks1 min
Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.251: Rigging equipment for material handling, NCCCO: Rigger Level I written exam outline, The Crosby Group: rigging hardware product and warnings information
Rigger Level I (NCCCO) cheat sheet: every key fact on one page →Next chapter: Load Control & Completing the Lift →Practice questions built from the published NCCCO Rigger Level I written examination outline and the consensus rigging practices of the ASME B30 series and the OSHA rigging regulations. CCO and NCCCO are marks of the National Commission for the Certification of Crane Operators; this site is not affiliated with or endorsed by NCCCO. This bank covers the WRITTEN examination only — Rigger Level I certification also requires a hands-on practical examination that no multiple-choice question can prepare you for, and there is no substitute for supervised practice with real gear. Capacity always comes from the identification tag and the manufacturer's rating for the specific sling, shackle or device in your hands, never from a practice question. Confirm current requirements with NCCCO before testing. Official exam outline →