Chapters0/30 ▾
Chapter 1 · Lesson 1 of 4
Knowing the weight of the load
1 min read
Every sling, shackle and hook in the rig is chosen against the weight it will carry, so the weight has to be known before anything is selected. Acceptable sources are documented ones: the manufacturer's data plate, shipping papers or a bill of lading, weight markings on the load, engineered drawings, or a calculation from the load's dimensions and material.
A foreman's guess, however experienced, is not on that list. When a guess and a data plate disagree, the data plate wins, and averaging the two is not a method.
A calculation is a valid source when the shape is simple. Example: a steel plate 8 ft by 4 ft and 1 in thick has a volume of 8 x 4 x 1/12 = about 2.67 cubic feet. At roughly 490 lb per cubic foot for steel, it weighs about 1,307 lb, before adding any rigging hung below the hook.
If there is no paper, no plate, no marking and no way to calculate, the weight must be established by a qualified source before rigging is chosen.
A crane's load indicator does not solve the problem: it reads only after the load is off the ground, which is after the slings were already picked. It is a cross-check on a known weight, not the source of one.
Check yourself
1. No shipping papers, data plate, markings or drawings exist for a load, and its weight cannot be calculated from its dimensions and material. What should the rigger do?
2. A foreman tells the rigger that a fabricated skid 'looks like about three tons.' The skid also carries a manufacturer's data plate listing its weight. Which figure should be used to select the rigging?
Facts checked 2026-11-15 · Sources: NCCCO: Rigger Level I written exam outline, OSHA 29 CFR 1926.251: Rigging equipment for material handling, OSHA 29 CFR 1910.184: Slings
Rigger Level I (NCCCO) cheat sheet: every key fact on one page →