Chapters0/30 ▾
Chapter 7 · Lesson 4 of 5
A smooth start and the trial lift
1 min read
The force in the rigging is the weight plus whatever it takes to accelerate it. Shock loading comes from rapid starts or stops: snatching up slack, jerking a stuck load free, a hard stop, or a load that drops and is caught by the slings.
The momentary force can be several times the static weight, and OSHA's sling rule prohibits shock loading outright.
The cure is simple: take up slack slowly and bring the load off the ground with a smooth start. Snapping the slings tight to seat them, lifting fast to clear the ground, or braking hard to prove the slings hold all add force the slings were not rated for.
Then lift a few inches and stop. This trial lift tests every rigging decision: a level hang shows the hook is over the center of gravity, and the pause shows whether the slings have seated, whether any leg is slipping and whether the load is holding.
Tags and capacities were checked before the slings went on, so that is not what this pause is for. Example: the load comes up a few inches and tips toward one end.
Land it, move or adjust the rigging toward the heavy end, and lift again. Raising it higher changes nothing, and having someone push the low end up puts a person in the fall zone.
Check yourself
1. What is a shock load, and why is it dangerous to rigging?
2. How should the hoist be run when first taking the weight of a load, so that shock loading is avoided?
Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1910.184: Slings, OSHA 29 CFR 1926.1425: Keeping clear of the load, NCCCO: Rigger Level I written exam outline
Rigger Level I (NCCCO) cheat sheet: every key fact on one page →