Chapters0/30 ▾
Chapter 7 · Lesson 3 of 5
Tag lines and rope knots
1 min read
A tag line lets the load be steadied and guided without anyone touching it or standing under it. One is rigged before the lift whenever wind, shape or the travel path could let the load swing or spin; weight, travel height and the number of sling legs do not decide that.
Tie it low on the load itself, not to the hook block or a sling leg, and make it long enough that the rigger stays outside the fall zone and clear of the travel path.
Hold it in the hands and never wrap it around a hand, arm or belt, so it can be let go instantly.
OSHA's crane rules in 1926.1425 keep everyone except those hooking, guiding or receiving the load out of the fall zone, and a tag line keeps even those workers clear, which is why steadying a load by hand or from underneath is wrong.
Example: a long panel keeps turning on the hook. Two tag lines at opposite ends act as a couple, so a light pull on either one stops the rotation while both handlers stand well back.
For joining two ropes of different diameter, use a sheet bend: the larger rope forms the bight and the smaller passes up through it and tucks under itself. A square knot is for ropes of the same size and can slip when sizes differ.
Check yourself
1. How should a tag line be rigged, and where does the rigger work while using it?
2. Under what condition should a tag line be rigged on a load before it leaves the ground?
Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1910.184: Slings, OSHA 29 CFR 1926.1425: Keeping clear of the load, NCCCO: Rigger Level I written exam outline
Rigger Level I (NCCCO) cheat sheet: every key fact on one page →