Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/30 ▾
← Hardware & Device Inspection

Chapter 4 · Lesson 3 of 4

Eyebolts, hoist rings, links and turnbuckles

1 min read

The other B30.26 hardware follows the same logic: permanent distortion or heat damage means the metal has changed, and missing identification means nobody can prove the rating.

A bent eyebolt shank or a stretched eye is a removal condition; grease on the threads, original machining marks and a light film of rust are normal. Excessive pitting and corrosion, not a light film, is what fails an item.

  • Swivel hoist rings: the ring must pivot and rotate freely when unloaded. A seized ring cannot line up with the pull and is side loaded.
  • Links, rings and swivels: an arc strike from a welding ground or weld spatter is heat damage and a crack starter, so it is a removal condition.
  • Turnbuckles: end fittings threaded only partway in are not fully engaged and must not be used. Some thread showing outside the frame is normal; what matters is engagement into the body. Markings worn unreadable also retire a turnbuckle, and stamping new marks by hand is an unauthorized modification.

Check yourself

1. A swivel hoist ring is being inspected before installation. Which finding requires it to be removed from service?

2. Which finding requires an eyebolt to be removed from service under ASME B30.26?

Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.251: Rigging equipment for material handling, OSHA 29 CFR 1910.184: Slings, NCCCO: Rigger Level I written exam outline

Rigger Level I (NCCCO) cheat sheet: every key fact on one page →