Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/30 ▾
← Hardware & Device Inspection

Chapter 4 · Lesson 2 of 4

Inspecting shackles and their pins

1 min read

A shackle is rated as a matched body and pin. Under ASME B30.26 the body shows the maker's name or trademark, the rated load and the size, and the pin shows the maker's name or trademark and its grade or material, which is how an inspector confirms the two belong together.

A replacement pin must meet the manufacturer's original specification. A bolt and nut in place of a lost pin takes the shackle out of service, whatever the bolt's grade, and derating does not make it acceptable.

  • Wear or gouging that reduces the bow or the pin by more than 10 percent of the original or catalog dimension, at any point, is a removal condition.
  • A screw pin must thread fully home with its shoulder flush against the body; a gap means incomplete engagement.
  • A crack is a growing defect: the shackle comes out at once and is kept where it cannot be reused.
  • Repairs and modifications are made only as the manufacturer or a qualified person specifies, and signs of unauthorized welding are a removal condition.

Example: a pin that measured 1.00 in new is retired once wear takes it below 0.90 in. Field welding a worn bow, even by a certified welder, destroys the heat treatment the rating depends on.

Check yourself

1. A rigger finds a shackle whose original pin is missing, with a bolt and nut fitted in its place. What is the correct determination?

2. Someone proposes to weld up a worn shackle bow in the field. What does ASME B30.26 require for repairs and modifications?

Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.251: Rigging equipment for material handling, OSHA 29 CFR 1910.184: Slings, NCCCO: Rigger Level I written exam outline

Rigger Level I (NCCCO) cheat sheet: every key fact on one page →