Chapters0/30 ▾
Chapter 1 · Lesson 4 of 4
Hands, body position and the authority to stop
1 min read
OSHA's rigging rules say hands and fingers stay out from between the sling and the load while the sling is being tightened. Slings are positioned before tension comes on and adjusted only with the tension released.
As the load leaves the ground, the rigger stands to the side, out of any bight, out of line with a taut leg, off the load and never between the load and a fixed object. Loads are guided with a tagline, not by hand.
Two load hazards come up often. Shock loading is a sudden application or release of force, such as snatching slack or catching a dropped load, and the peak can be several times the static weight.
Side loading is force across a component instead of along its line of pull, as when a load is dragged before it lifts; shackles, hooks and eyebolts lose much of their rating that way.
Sharp, sheared or burred edges where a sling bears call for softeners or corner protection. Finally, anyone on the crew who sees an unsafe condition may stop the lift, and a hazard such as soft ground at the landing goes to the lift supervisor and is fixed before the pick, not mentioned at the end of the shift.
Check yourself
1. What is shock loading, and why must it be avoided?
2. A rigger's helper notices a badly damaged sling just as the load starts to lift. Who has the authority to stop the lift?
Facts checked 2026-11-15 · Sources: NCCCO: Rigger Level I written exam outline, OSHA 29 CFR 1926.251: Rigging equipment for material handling, OSHA 29 CFR 1910.184: Slings
Rigger Level I (NCCCO) cheat sheet: every key fact on one page →