Chapters0/30 ▾
Chapter 3 · Lesson 3 of 4
Chain, metal mesh and sling hooks
1 min read
Alloy chain wears where the links bear on each other, and that wear is judged by measurement: the thinnest point is gauged and compared with the minimum thickness the standard lists for that size.
Weld splatter on the links is a removal condition because the arc reheated the alloy and the bead can hide a crack; light rust that wipes off is not.
Heat is the other chain topic. Under OSHA 1910.184, a chain sling heated above 1,000 degrees F is permanently retired, and above 600 degrees F in service its working load must be reduced as the maker directs. Quenching hot chain in water restores nothing.
Metal mesh slings come out when the mesh wire diameter is reduced 25 percent by abrasion or 15 percent by corrosion; corrosion gets the tighter number because it works into the wire and joints. Sling hooks give another ASME and OSHA pair.
ASME B30.10 removes a hook at a 5 percent increase in throat opening, not to exceed 1/4 in, or any visible twist. OSHA 1910.184 uses more than 15 percent at the narrowest point or a twist over 10 degrees.
Example: a 4 in throat reaches the ASME limit after 0.20 in of spread; on a 6 in throat, 5 percent would be 0.30 in, so the 1/4 in cap governs.
Check yourself
1. Under OSHA 29 CFR 1910.184, an alloy steel chain sling heated above which temperature must be permanently removed from service?
2. A rigger inspecting an alloy steel chain sling finds the links worn thin where they bear against one another. Under ASME B30.9, what determines whether the sling is removed from service?
Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1910.184: Slings, OSHA 29 CFR 1926.251: Rigging equipment for material handling, NCCCO: Rigger Level I written exam outline
Rigger Level I (NCCCO) cheat sheet: every key fact on one page →