Chapters0/30 ▾
Chapter 6 · Lesson 4 of 4
Clamps, beams, gantries, rollers and jacks
1 min read
Below-the-hook devices are rated only in the configuration they were designed for. A beam clamp must match the flange width and thickness and sit square and centered within its rating; shims, a tilted clamp or an off-center bite turn the flange into a lever.
A vertical plate clamp grips by cam action that tightens with load, so the plate goes fully into the throat, one plate at a time, with no side pull.
A spreader holds lift points apart so the legs hang closer to vertical and the load is not squeezed; an equalizer pivots to share the load between two points or two lines. A gantry trolley must fit its beam flange, with the load hanging plumb and the legs on firm, level footing.
Moving loads on the ground follows the same idea. On machinery rollers, keep the center of gravity low and centered over the rollers, on a level, clean path, and never walk in the direction of travel.
A jack is a lifting device, not a holding device: it sits on a firm, level base, its head bears on a solid part of the load, and the raised load is blocked and cribbed separately before anyone reaches under it.
Check yourself
1. A hydraulic jack raises one corner of a heavy machine so work can be done beneath it. What is required before anyone reaches under the load?
2. A beam clamp will be attached to a structural steel beam to hang a hoist. Which selection and setup is correct?
Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.251: Rigging equipment for material handling, NCCCO: Rigger Level I written exam outline, The Crosby Group: rigging hardware product and warnings information
Rigger Level I (NCCCO) cheat sheet: every key fact on one page →