Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/30 ▾
← Load Control & Completing the Lift

Chapter 7 · Lesson 2 of 5

Sling angles and leg tension

1 min read

Sling angle is measured from the horizontal. As a leg leans over, it must pull harder along its length to supply the same upward share. Leg tension = (weight / number of legs) x load angle factor, and the factor is never below 1.0.

Angle from horizontalLoad angle factor
90 degrees1.000
60 degrees1.155
45 degrees1.414
30 degrees2.000

Example: a 6,000 lb load on two legs at 60 degrees gives 3,000 x 1.155 = about 3,465 lb per leg. The same idea without a table: share x sling length / vertical height. With 10 ft legs and 8 ft of height, a 7,200 lb load gives 3,600 x 10 / 8 = 4,500 lb per leg.

Below 30 degrees the rise is steep, about 2.37 at 25 degrees, so angles that flat are not used unless the sling maker or a qualified person approves.

When an adjustable bridle levels an off-center load, shorten the leg at the heavy end; the legs still carry unequal shares, so each must be rated for its own, not for half the weight.

Check yourself

1. An 8,000 lb load hangs on a two-leg bridle with each leg at 60 degrees from horizontal. Using a load angle factor of 1.155 for 60 degrees, what is the tension in each leg?

2. A lift plan shows a two-leg bridle working at a horizontal sling angle of 25 degrees. What is the correct response to that angle?

Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1910.184: Slings, OSHA 29 CFR 1926.1425: Keeping clear of the load, NCCCO: Rigger Level I written exam outline

Rigger Level I (NCCCO) cheat sheet: every key fact on one page →