Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/30 ▾
← Load Control & Completing the Lift

Chapter 7 · Lesson 1 of 5

Finding and using the center of gravity

1 min read

The center of gravity is the single point where the whole weight of the load can be treated as acting. It is rarely the geometric middle, because material is almost never spread evenly; it shifts toward concentrated mass, such as the motor end of a pump skid.

Lifting lugs are welded where the structure is strong, not necessarily over the balance point, so their position does not locate it.

A freely suspended load always hangs with its center of gravity under the hook. If the hook starts off to one side, the load swings sideways the moment it is free, which can strike workers and shift slings in the hook.

Attachment points above the center of gravity make the load hang like a pendulum and return to level; points level with it leave it neutral; points below it let it roll over.

With two vertical slings, each carries the weight times the distance from the center of gravity to the other sling, divided by the span.

Example: a 12,000 lb skid with slings 24 ft apart and its center of gravity 8 ft from sling A puts 12,000 x 16 / 24 = 8,000 lb on A and 4,000 lb on B. The sling nearer the center of gravity carries more.

Check yourself

1. How does the height of the sling attachment points relative to the load's center of gravity affect stability?

2. In rigging, what does the center of gravity of a load refer to?

Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1910.184: Slings, OSHA 29 CFR 1926.1425: Keeping clear of the load, NCCCO: Rigger Level I written exam outline

Rigger Level I (NCCCO) cheat sheet: every key fact on one page →