Chapters0/30 ▾
Chapter 5 · Lesson 4 of 4
Handling, protecting and storing slings
1 min read
OSHA's sling rules forbid shortening a sling with knots, bolts or other makeshift devices, and forbid kinking a sling leg. A knot crushes one spot and can roughly halve the sling's strength; a bolt loads the sling across a tiny area. Use a rated shortening fitting made for that sling, or pick a sling of the right length.
Twists and kinks are straightened before the slack is taken up, because tension sets the damage in rather than pulling it out. A sling eye must fit its hook freely and seat in the bowl; driving it over a larger hook stretches the eye and bends the sling over too small a radius.
- Edge protection: for synthetics, the test is whether the corner radius meets the maker's recommendation, not whether the edge feels sharp, and the protection must resist being cut through.
- Never pull a sling from under a resting load; lift the load, set it on blocking, then draw the sling out by hand.
- Store slings clean and dry on a rack, away from sunlight and chemicals, and carry them rather than dragging them through grit. Rigging that is not in use is removed from the immediate work area so it is not a trip or struck-by hazard.
Check yourself
1. A load has been landed and is resting on the slings. What is the correct way to free the slings?
2. A sling is several feet longer than the pick needs. Which way of shortening it is acceptable?
Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1910.184: Slings, OSHA 29 CFR 1926.251: Rigging equipment for material handling, NCCCO: Rigger Level I written exam outline
Rigger Level I (NCCCO) cheat sheet: every key fact on one page →