Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Safety0/5
    1. Worker rights, employer duties and reporting hazards
    2. The hierarchy of controls and personal protective equipment
    3. Lockout/tagout, machine guarding and electrical hazards
    4. Hazard communication, chemical storage and fire
    5. Confined spaces and ergonomics
  2. 2.Quality Practices & Inspection0/4
    1. Quality systems, audits and the internal customer
    2. Prevention versus detection: cost of quality and inspection points
    3. Control charts and variation
    4. Root cause tools, nonconforming product and corrective action
  3. 3.Measurement & Blueprint Reading0/5
    1. Choosing and reading micrometers and calipers
    2. Indicators, transfer gauges and go/no-go gauges
    3. Calibration and conditions that affect accuracy
    4. Reading the print: views, lines, scale and the title block
    5. Limits, tolerance, allowance and GD&T basics
  4. 4.Manufacturing Processes & Materials0/5
    1. How parts are shaped: casting, molding, forging, machining and additive
    2. Joining, heat treating and finishing
    3. Materials and their properties
    4. Volume, setup cost, takt time and the bottleneck
    5. Work orders, travelers, traceability and connected machines
  5. 5.Lean & Continuous Improvement0/5
    1. Value-added, non-value-added and necessary work
    2. The eight wastes
    3. 5S, visual management and the andon
    4. Standard work, kaizen and plan-do-check-act
    5. Pull, value stream maps, quick changeover and poka-yoke
  6. 6.Maintenance Awareness0/5
    1. Reactive, preventive and predictive maintenance, and TPM
    2. PM discipline, maintenance records and warning signs
    3. Lockout/tagout and stored energy
    4. Lubrication, bearings and shaft alignment
    5. Belts, chains, motor overloads and fluid power
Saved in this browser. Move it to another device →
← Safety

Chapter 1 · Lesson 3 of 5

Lockout/tagout, machine guarding and electrical hazards

1 min read

The OSHA standard for the control of hazardous energy sets the order for locking out a machine before servicing: notify affected employees, shut the machine down, isolate every energy source, apply each authorized worker's personal lock and tag, release or block stored energy, then verify zero energy by trying the controls and returning them to off.

Stored energy is the step candidates forget: springs, hydraulic and air pressure, capacitors and raised parts can still move after the supply is cut.

  • The authorized employee locks out and does the servicing; the affected employee, such as the machine's regular operator, is notified before and after.
  • In group lockout each worker puts a personal lock on a group hasp and removes only that lock, so nobody is released from protection by someone else.
  • A missing point-of-operation guard means stop the job, keep the machine out of use and tell the supervisor; slowing down or standing back does not control an amputation hazard.
  • An arc-flash boundary on a panel label marks the distance inside which an arcing fault could cause serious burns without arc-rated PPE.

Check yourself

1. Three workers will service the same conveyor during one shift. How should the locks be handled?

2. A technician has notified affected employees, shut the machine down, isolated its energy sources, and applied a personal lock and tag. What must happen next?

Facts checked 2026-11-15 · Sources: MSSC: Certified Production Technician (CPT 4.0), OSHA 29 CFR 1910.147: The control of hazardous energy (lockout/tagout), OSHA: Hazard Communication

Production Technician cheat sheet: every key fact on one page →