Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Safety0/5
    1. Worker rights, employer duties and reporting hazards
    2. The hierarchy of controls and personal protective equipment
    3. Lockout/tagout, machine guarding and electrical hazards
    4. Hazard communication, chemical storage and fire
    5. Confined spaces and ergonomics
  2. 2.Quality Practices & Inspection0/4
    1. Quality systems, audits and the internal customer
    2. Prevention versus detection: cost of quality and inspection points
    3. Control charts and variation
    4. Root cause tools, nonconforming product and corrective action
  3. 3.Measurement & Blueprint Reading0/5
    1. Choosing and reading micrometers and calipers
    2. Indicators, transfer gauges and go/no-go gauges
    3. Calibration and conditions that affect accuracy
    4. Reading the print: views, lines, scale and the title block
    5. Limits, tolerance, allowance and GD&T basics
  4. 4.Manufacturing Processes & Materials0/5
    1. How parts are shaped: casting, molding, forging, machining and additive
    2. Joining, heat treating and finishing
    3. Materials and their properties
    4. Volume, setup cost, takt time and the bottleneck
    5. Work orders, travelers, traceability and connected machines
  5. 5.Lean & Continuous Improvement0/5
    1. Value-added, non-value-added and necessary work
    2. The eight wastes
    3. 5S, visual management and the andon
    4. Standard work, kaizen and plan-do-check-act
    5. Pull, value stream maps, quick changeover and poka-yoke
  6. 6.Maintenance Awareness0/5
    1. Reactive, preventive and predictive maintenance, and TPM
    2. PM discipline, maintenance records and warning signs
    3. Lockout/tagout and stored energy
    4. Lubrication, bearings and shaft alignment
    5. Belts, chains, motor overloads and fluid power
Saved in this browser. Move it to another device →
← Measurement & Blueprint Reading

Chapter 3 · Lesson 4 of 5

Reading the print: views, lines, scale and the title block

1 min read

Most drawings in the United States use third-angle projection, where each view is placed on the side it is seen from: the right-side view sits to the right of the front view at the same height, and the top view sits above it. First-angle projection reverses those positions, so check the projection symbol near the title block before reading any drawing.

The alphabet of lines tells you what each line means.

  • Hidden line: evenly spaced short dashes, for edges behind visible material such as a counterbore.
  • Center line: alternating long and short dashes, for the axis of a hole or round feature.
  • Phantom line: long dashes with two short ones, for an alternate position of a moving part; a cutting-plane line is heavy with arrowheads.

Never measure a print with a rule, whatever the scale note says, because copying and paper changes distort drawn lengths; a missing dimension goes back to engineering.

A dimension with no tolerance beside it takes the default in the title block for its number of decimal places, so 3.50 uses the two-place line and 3.500 the three-place line. Example: a slot drawn on a SCALE 1:2 print with no dimension is not assumed to be twice its drawn length; the technician asks engineering for the value.

Check yourself

1. A line drawn as a series of short dashes on a multi-view drawing represents what?

2. On a drawing made in third-angle projection, where is the right-side view placed?

Facts checked 2026-11-15 · Sources: MSSC: Certified Production Technician (CPT 4.0), NIST: Metrological traceability

Production Technician cheat sheet: every key fact on one page →