Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Safety0/5
    1. Worker rights, employer duties and reporting hazards
    2. The hierarchy of controls and personal protective equipment
    3. Lockout/tagout, machine guarding and electrical hazards
    4. Hazard communication, chemical storage and fire
    5. Confined spaces and ergonomics
  2. 2.Quality Practices & Inspection0/4
    1. Quality systems, audits and the internal customer
    2. Prevention versus detection: cost of quality and inspection points
    3. Control charts and variation
    4. Root cause tools, nonconforming product and corrective action
  3. 3.Measurement & Blueprint Reading0/5
    1. Choosing and reading micrometers and calipers
    2. Indicators, transfer gauges and go/no-go gauges
    3. Calibration and conditions that affect accuracy
    4. Reading the print: views, lines, scale and the title block
    5. Limits, tolerance, allowance and GD&T basics
  4. 4.Manufacturing Processes & Materials0/5
    1. How parts are shaped: casting, molding, forging, machining and additive
    2. Joining, heat treating and finishing
    3. Materials and their properties
    4. Volume, setup cost, takt time and the bottleneck
    5. Work orders, travelers, traceability and connected machines
  5. 5.Lean & Continuous Improvement0/5
    1. Value-added, non-value-added and necessary work
    2. The eight wastes
    3. 5S, visual management and the andon
    4. Standard work, kaizen and plan-do-check-act
    5. Pull, value stream maps, quick changeover and poka-yoke
  6. 6.Maintenance Awareness0/5
    1. Reactive, preventive and predictive maintenance, and TPM
    2. PM discipline, maintenance records and warning signs
    3. Lockout/tagout and stored energy
    4. Lubrication, bearings and shaft alignment
    5. Belts, chains, motor overloads and fluid power
Saved in this browser. Move it to another device →
← Manufacturing Processes & Materials

Chapter 4 · Lesson 2 of 5

Joining, heat treating and finishing

1 min read

Joining methods split into permanent and non-permanent. Welds, rivets and structural adhesives are permanent: the joint has to be cut, drilled or destroyed to open it. Threaded fasteners such as bolts and lock nuts are non-permanent, so they can be loosened and tightened again to the specified torque many times.

When a stem says a part must come off for service, the answer is a threaded fastener.

Heat treating changes a metal's properties without changing its shape. Annealing heats steel and cools it slowly, so the grain structure re-forms, hardness drops, ductility returns and internal stress is relieved.

It is the fix for a part that cold working has left hard and ready to crack. Quench hardening, flame hardening and case carburizing all go the other way and add hardness.

Finishing operations change the surface. Deburring removes sharp edges, and blasting or polishing changes texture, but none of these protects steel from rust. A zinc coating does, because it seals out moisture and corrodes in place of the iron, so even a scratch stays protected. Example: a steel rack going outside needs a protective coating, not just a polish.

Check yourself

1. Cold working has left a steel bracket hard and likely to crack if it is bent any further. Which heat treatment softens it and relieves internal stress?

2. A gearbox cover must be taken off for scheduled service and put back on afterward. Which joining method suits it?

Facts checked 2026-11-15 · Sources: MSSC: Certified Production Technician (CPT 4.0)

Production Technician cheat sheet: every key fact on one page →