Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Safety0/5
    1. Worker rights, employer duties and reporting hazards
    2. The hierarchy of controls and personal protective equipment
    3. Lockout/tagout, machine guarding and electrical hazards
    4. Hazard communication, chemical storage and fire
    5. Confined spaces and ergonomics
  2. 2.Quality Practices & Inspection0/4
    1. Quality systems, audits and the internal customer
    2. Prevention versus detection: cost of quality and inspection points
    3. Control charts and variation
    4. Root cause tools, nonconforming product and corrective action
  3. 3.Measurement & Blueprint Reading0/5
    1. Choosing and reading micrometers and calipers
    2. Indicators, transfer gauges and go/no-go gauges
    3. Calibration and conditions that affect accuracy
    4. Reading the print: views, lines, scale and the title block
    5. Limits, tolerance, allowance and GD&T basics
  4. 4.Manufacturing Processes & Materials0/5
    1. How parts are shaped: casting, molding, forging, machining and additive
    2. Joining, heat treating and finishing
    3. Materials and their properties
    4. Volume, setup cost, takt time and the bottleneck
    5. Work orders, travelers, traceability and connected machines
  5. 5.Lean & Continuous Improvement0/5
    1. Value-added, non-value-added and necessary work
    2. The eight wastes
    3. 5S, visual management and the andon
    4. Standard work, kaizen and plan-do-check-act
    5. Pull, value stream maps, quick changeover and poka-yoke
  6. 6.Maintenance Awareness0/5
    1. Reactive, preventive and predictive maintenance, and TPM
    2. PM discipline, maintenance records and warning signs
    3. Lockout/tagout and stored energy
    4. Lubrication, bearings and shaft alignment
    5. Belts, chains, motor overloads and fluid power
Saved in this browser. Move it to another device →
← Lean & Continuous Improvement

Chapter 5 · Lesson 4 of 5

Standard work, kaizen and plan-do-check-act

1 min read

Standard work records the current best-known sequence, method and time for a job. It has to exist before improvement, because without it every operator works a little differently and a measured gain could come from that variation instead of the change. It is not frozen: a proven improvement becomes the new standard.

Kaizen means many small, frequent improvements made by the people doing the work, often in short team events, rather than occasional large engineering projects. Teams run each change through plan-do-check-act.

Plan the countermeasure, Do it as a small trial, Check the results against the baseline data taken before, and only then Act by writing it into standard work and spreading it. Example: a team moves a gauge closer and times the job for one shift; if the times beat the old baseline, Act makes the new location standard.

Communication is part of the system. An operator who makes a temporary adjustment to hold a drifting dimension tells the incoming operator at handover and records it in the shift log, so the cause gets found instead of each shift quietly adjusting around it.

Check yourself

1. A team ran a trial countermeasure on one shift. In plan-do-check-act, what does the Check step require?

2. Why must standard work exist before a process can be improved?

Facts checked 2026-11-15 · Sources: MSSC: Certified Production Technician (CPT 4.0)

Production Technician cheat sheet: every key fact on one page →