Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Safety0/5
    1. Worker rights, employer duties and reporting hazards
    2. The hierarchy of controls and personal protective equipment
    3. Lockout/tagout, machine guarding and electrical hazards
    4. Hazard communication, chemical storage and fire
    5. Confined spaces and ergonomics
  2. 2.Quality Practices & Inspection0/4
    1. Quality systems, audits and the internal customer
    2. Prevention versus detection: cost of quality and inspection points
    3. Control charts and variation
    4. Root cause tools, nonconforming product and corrective action
  3. 3.Measurement & Blueprint Reading0/5
    1. Choosing and reading micrometers and calipers
    2. Indicators, transfer gauges and go/no-go gauges
    3. Calibration and conditions that affect accuracy
    4. Reading the print: views, lines, scale and the title block
    5. Limits, tolerance, allowance and GD&T basics
  4. 4.Manufacturing Processes & Materials0/5
    1. How parts are shaped: casting, molding, forging, machining and additive
    2. Joining, heat treating and finishing
    3. Materials and their properties
    4. Volume, setup cost, takt time and the bottleneck
    5. Work orders, travelers, traceability and connected machines
  5. 5.Lean & Continuous Improvement0/5
    1. Value-added, non-value-added and necessary work
    2. The eight wastes
    3. 5S, visual management and the andon
    4. Standard work, kaizen and plan-do-check-act
    5. Pull, value stream maps, quick changeover and poka-yoke
  6. 6.Maintenance Awareness0/5
    1. Reactive, preventive and predictive maintenance, and TPM
    2. PM discipline, maintenance records and warning signs
    3. Lockout/tagout and stored energy
    4. Lubrication, bearings and shaft alignment
    5. Belts, chains, motor overloads and fluid power
Saved in this browser. Move it to another device →
← Manufacturing Processes & Materials

Chapter 4 · Lesson 1 of 5

How parts are shaped: casting, molding, forging, machining and additive

1 min read

Most exam questions about processes come down to one idea: what happens to the material. Some processes fill a cavity with liquid material, some push solid material into a new shape, some cut material away, and one builds material up. If you can name which of these a stem describes, you can usually find the answer.

ProcessWhat happensGood fit
Sand castingMolten metal fills a mold; cores form internal passagesComplex metal parts with hidden cavities
Injection moldingMolten thermoplastic is forced into a steel moldHuge runs of identical plastic parts
ForgingA hammer or press moves solid metal into a dieStrong parts with grain that follows the shape
MachiningA tool cuts chips until the size is reachedPrecise features, low volumes
AdditiveMaterial is added layer by layer from a digital modelPrototypes, fixtures, shapes that cannot be cut

Machining questions also test cutting settings. Feed is how far the tool advances each revolution. Example: if an operator raises the feed on a finishing pass, the tool marks get deeper and farther apart, so the surface gets rougher, and cutting force and heat rise, which shortens tool life. That is why finishing passes use a light feed.

Check yourself

1. A cast iron pump housing needs internal passages that would be very hard to machine. Which process forms the part by filling a mold with molten metal?

2. On a lathe the operator doubles the feed rate and leaves every other setting the same. What happens to the machined surface?

Facts checked 2026-11-15 · Sources: MSSC: Certified Production Technician (CPT 4.0)

Production Technician cheat sheet: every key fact on one page →