Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾

0 of 29 lessons finished

Continue: The eight wastes
  1. 1.Safety0/5
    1. Worker rights, employer duties and reporting hazards
    2. The hierarchy of controls and personal protective equipment
    3. Lockout/tagout, machine guarding and electrical hazards
    4. Hazard communication, chemical storage and fire
    5. Confined spaces and ergonomics
  2. 2.Quality Practices & Inspection0/4
    1. Quality systems, audits and the internal customer
    2. Prevention versus detection: cost of quality and inspection points
    3. Control charts and variation
    4. Root cause tools, nonconforming product and corrective action
  3. 3.Measurement & Blueprint Reading0/5
    1. Choosing and reading micrometers and calipers
    2. Indicators, transfer gauges and go/no-go gauges
    3. Calibration and conditions that affect accuracy
    4. Reading the print: views, lines, scale and the title block
    5. Limits, tolerance, allowance and GD&T basics
  4. 4.Manufacturing Processes & Materials0/5
    1. How parts are shaped: casting, molding, forging, machining and additive
    2. Joining, heat treating and finishing
    3. Materials and their properties
    4. Volume, setup cost, takt time and the bottleneck
    5. Work orders, travelers, traceability and connected machines
  5. 5.Lean & Continuous Improvement0/5
    1. Value-added, non-value-added and necessary work
    2. The eight wastes
    3. 5S, visual management and the andon
    4. Standard work, kaizen and plan-do-check-act
    5. Pull, value stream maps, quick changeover and poka-yoke
  6. 6.Maintenance Awareness0/5
    1. Reactive, preventive and predictive maintenance, and TPM
    2. PM discipline, maintenance records and warning signs
    3. Lockout/tagout and stored energy
    4. Lubrication, bearings and shaft alignment
    5. Belts, chains, motor overloads and fluid power
Saved in this browser. Move it to another device →
← Lean & Continuous Improvement

Chapter 5 · Lesson 1 of 5

Value-added, non-value-added and necessary work

1 min read

Lean defines value from the customer's point of view. A step adds value only when it physically transforms the material, or the information, toward what the customer ordered, so the customer would be willing to pay for it. Being on the routing sheet, being done by a skilled operator, or keeping a machine busy does not make a step value-added.

A busy machine making parts nobody ordered is overproduction.

CategoryExample in a machining cellLean response
Value-addedDrilling a hole the print calls forKeep it and do it right the first time
Non-value-added but necessaryTesting the guard interlock before a runKeep it; required safety checks are never cut
Pure wasteRedrilling a hole that came out off-centerRemove it by fixing the cause

Inspection, moving and counting are non-value-added: they use labor and time but do not change the product. Inspection is often needed under the current process, yet the customer does not pay extra for it, so lean tries to design it out through error-proofing.

A finishing step the drawing calls out, such as deburring a specified edge, is value-added because the customer asked for it.

Check yourself

1. Which activity is best described as non-value-added but currently necessary?

2. An operator polishes a surface to a finer finish than the drawing requires because it looks better. Which waste is this?

Facts checked 2026-11-15 · Sources: MSSC: Certified Production Technician (CPT 4.0)

Production Technician cheat sheet: every key fact on one page →