Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Safety0/5
    1. Worker rights, employer duties and reporting hazards
    2. The hierarchy of controls and personal protective equipment
    3. Lockout/tagout, machine guarding and electrical hazards
    4. Hazard communication, chemical storage and fire
    5. Confined spaces and ergonomics
  2. 2.Quality Practices & Inspection0/4
    1. Quality systems, audits and the internal customer
    2. Prevention versus detection: cost of quality and inspection points
    3. Control charts and variation
    4. Root cause tools, nonconforming product and corrective action
  3. 3.Measurement & Blueprint Reading0/5
    1. Choosing and reading micrometers and calipers
    2. Indicators, transfer gauges and go/no-go gauges
    3. Calibration and conditions that affect accuracy
    4. Reading the print: views, lines, scale and the title block
    5. Limits, tolerance, allowance and GD&T basics
  4. 4.Manufacturing Processes & Materials0/5
    1. How parts are shaped: casting, molding, forging, machining and additive
    2. Joining, heat treating and finishing
    3. Materials and their properties
    4. Volume, setup cost, takt time and the bottleneck
    5. Work orders, travelers, traceability and connected machines
  5. 5.Lean & Continuous Improvement0/5
    1. Value-added, non-value-added and necessary work
    2. The eight wastes
    3. 5S, visual management and the andon
    4. Standard work, kaizen and plan-do-check-act
    5. Pull, value stream maps, quick changeover and poka-yoke
  6. 6.Maintenance Awareness0/5
    1. Reactive, preventive and predictive maintenance, and TPM
    2. PM discipline, maintenance records and warning signs
    3. Lockout/tagout and stored energy
    4. Lubrication, bearings and shaft alignment
    5. Belts, chains, motor overloads and fluid power
Saved in this browser. Move it to another device →
← Maintenance Awareness

Chapter 6 · Lesson 3 of 5

Lockout/tagout and stored energy

1 min read

The federal OSHA standard on the control of hazardous energy requires a written procedure for shutting down and isolating machines before service.

In outline: notify affected employees, shut the machine down, isolate every energy source, apply each authorized worker's lock and tag, relieve or block stored energy, and verify that the machine cannot start. Always follow the specific procedure written for that machine.

Locking the disconnect controls only the source. Energy can still be stored in hydraulic accumulators, springs, capacitors, pressurized lines and raised parts, and any of it can move the machine.

Example: a press is locked out but its accumulator is still charged; the pressure must be bled off and zero pressure confirmed at the machine before anyone reaches in. Cycling the machine to use up the pressure, or just tagging the accumulator, is wrong.

Restoring the machine has its own steps: check that tools and guards are back in place, make sure everyone is clear, and once the locks are removed, notify affected employees before the machine is started.

Check yourself

1. A press is de-energized and locked out, but its hydraulic accumulator is still charged. What must happen before work starts?

2. Three workers are locked out on the same conveyor. Under the federal energy-control rule, who may remove a particular padlock?

Facts checked 2026-11-15 · Sources: MSSC: Certified Production Technician (CPT 4.0), OSHA 29 CFR 1910.147: The control of hazardous energy (lockout/tagout)

Production Technician cheat sheet: every key fact on one page →