Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Safety0/4
    1. Lockout, tagout and stored electrical energy
    2. Refrigerant, cylinders and pressure hazards
    3. Carbon monoxide and combustion hazards
    4. PPE, brazing and job-site hazards
  2. 2.Tools & Measurement0/5
    1. Measuring temperature and proving the thermometer
    2. Humidity, wet bulb and dew point
    3. Gauge pressure, absolute pressure and vacuum
    4. Using electrical meters correctly
    5. Airflow, leak detection and charging tools
  3. 3.Basic Electrical0/4
    1. Ohm's law, power and power factor
    2. Series, parallel and reading a ladder diagram
    3. Transformers, single-phase and three-phase power
    4. Single-phase motors, capacitors and winding tests
  4. 4.Science & Refrigeration Cycle0/4
    1. Heat, sensible and latent heat, and heat transfer
    2. Saturation and the four main components
    3. Calculating superheat and subcooling
    4. Metering devices and reading the charge
  5. 5.Construction, Comfort & Airflow0/4
    1. The building envelope: insulation, air sealing and windows
    2. Loads, equipment sizing and comfort
    3. Airflow, static pressure and capacity
    4. Duct leakage, noise, filters and ventilation
  6. 6.AC Components & Operation0/4
    1. Compressors and keeping liquid out
    2. Outdoor coil, indoor coil and condensate
    3. Metering devices, the TXV bulb and charging method
    4. Line sets, accessories, service valves and thermostats
  7. 7.AC Diagnosis & Service0/4
    1. Reading superheat and subcooling patterns
    2. Troubleshooting the control circuit
    3. Compressor electrical faults
    4. Airside, static pressure and condensate problems
Saved in this browser. Move it to another device →
← Safety

Chapter 1 · Lesson 4 of 4

PPE, brazing and job-site hazards

1 min read

Personal protective equipment is matched to the task.

Safety glasses with side shields are primary eye protection, and a face shield is worn over them because a shield can lift, crack or let chips under it. Brazing calls for shaded eye protection and leather gloves, since the torch gives off intense light, sparks and hot metal, and rubber, nitrile or cotton can melt or ignite.

Ventilation matters because some fluxes and alloys give off toxic fumes.

  • Hot work indoors: clear or shield combustibles, stage an extinguisher within reach, and keep a fire watch after the torch is off.
  • Near overhead energized lines, use a fiberglass or wood ladder; rubber feet do not make aluminum safe.
  • Lift with a straight back and the legs, keep the load close, and do not twist.
  • In attics, walk only on joists or planking and bring your own light; drywall carries no load.
  • Read the current safety data sheet for a chemical before using it; the employer must keep these sheets accessible.

Example: a technician must braze a line set beside a wood-framed wall in a finished closet. The right preparation is moving stored items out, shielding the framing, placing an extinguisher, and staying to watch for smoldering after the joint is made.

Check yourself

1. Before brazing a line set inside a finished building, what does safe hot-work practice require?

2. Which personal protective equipment is appropriate while brazing refrigerant tubing?

Facts checked 2026-11-15 · Sources: NATE: Certification exams, OSHA 29 CFR 1910.147: The control of hazardous energy (lockout/tagout)

NATE HVAC cheat sheet: every key fact on one page →