Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Safety0/4
    1. Lockout, tagout and stored electrical energy
    2. Refrigerant, cylinders and pressure hazards
    3. Carbon monoxide and combustion hazards
    4. PPE, brazing and job-site hazards
  2. 2.Tools & Measurement0/5
    1. Measuring temperature and proving the thermometer
    2. Humidity, wet bulb and dew point
    3. Gauge pressure, absolute pressure and vacuum
    4. Using electrical meters correctly
    5. Airflow, leak detection and charging tools
  3. 3.Basic Electrical0/4
    1. Ohm's law, power and power factor
    2. Series, parallel and reading a ladder diagram
    3. Transformers, single-phase and three-phase power
    4. Single-phase motors, capacitors and winding tests
  4. 4.Science & Refrigeration Cycle0/4
    1. Heat, sensible and latent heat, and heat transfer
    2. Saturation and the four main components
    3. Calculating superheat and subcooling
    4. Metering devices and reading the charge
  5. 5.Construction, Comfort & Airflow0/4
    1. The building envelope: insulation, air sealing and windows
    2. Loads, equipment sizing and comfort
    3. Airflow, static pressure and capacity
    4. Duct leakage, noise, filters and ventilation
  6. 6.AC Components & Operation0/4
    1. Compressors and keeping liquid out
    2. Outdoor coil, indoor coil and condensate
    3. Metering devices, the TXV bulb and charging method
    4. Line sets, accessories, service valves and thermostats
  7. 7.AC Diagnosis & Service0/4
    1. Reading superheat and subcooling patterns
    2. Troubleshooting the control circuit
    3. Compressor electrical faults
    4. Airside, static pressure and condensate problems
Saved in this browser. Move it to another device →
← AC Components & Operation

Chapter 6 · Lesson 1 of 4

Compressors and keeping liquid out

1 min read

A reciprocating compressor uses pistons with suction and discharge reed valves. A scroll compressor traps gas between a fixed scroll and an orbiting scroll and squeezes it continuously toward the center, so it needs no reed valves, runs smoother and tolerates small amounts of liquid better.

Either way, a compressor is built to pump vapor. Liquid does not compress, so a slug of it puts huge force on valves, pistons and scroll flanks, and liquid refrigerant also washes the oil off bearings.

PartWhereJob
Crankcase heaterOn the compressorKeeps oil warm during the off cycle so refrigerant does not migrate into it
AccumulatorSuction line, low sideTraps liquid leaving the evaporator and meters oil back through a small hole
ReceiverLiquid line, high sideStores surplus liquid for a variable charge

Example: a heat-pump compressor sits in a cold yard all night. Refrigerant migrates to the coldest place and dissolves into the oil. Without a working crankcase heater, the oil foams at start-up and the compressor loses lubrication.

Check yourself

1. A suction-line accumulator is installed on a split system. How does it protect the compressor during normal operation?

2. Why is liquid refrigerant that reaches the compressor cylinder or scroll set destructive?

Facts checked 2026-11-15 · Sources: NATE: Certification exams

NATE HVAC cheat sheet: every key fact on one page →