Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Safety0/4
    1. Lockout, tagout and stored electrical energy
    2. Refrigerant, cylinders and pressure hazards
    3. Carbon monoxide and combustion hazards
    4. PPE, brazing and job-site hazards
  2. 2.Tools & Measurement0/5
    1. Measuring temperature and proving the thermometer
    2. Humidity, wet bulb and dew point
    3. Gauge pressure, absolute pressure and vacuum
    4. Using electrical meters correctly
    5. Airflow, leak detection and charging tools
  3. 3.Basic Electrical0/4
    1. Ohm's law, power and power factor
    2. Series, parallel and reading a ladder diagram
    3. Transformers, single-phase and three-phase power
    4. Single-phase motors, capacitors and winding tests
  4. 4.Science & Refrigeration Cycle0/4
    1. Heat, sensible and latent heat, and heat transfer
    2. Saturation and the four main components
    3. Calculating superheat and subcooling
    4. Metering devices and reading the charge
  5. 5.Construction, Comfort & Airflow0/4
    1. The building envelope: insulation, air sealing and windows
    2. Loads, equipment sizing and comfort
    3. Airflow, static pressure and capacity
    4. Duct leakage, noise, filters and ventilation
  6. 6.AC Components & Operation0/4
    1. Compressors and keeping liquid out
    2. Outdoor coil, indoor coil and condensate
    3. Metering devices, the TXV bulb and charging method
    4. Line sets, accessories, service valves and thermostats
  7. 7.AC Diagnosis & Service0/4
    1. Reading superheat and subcooling patterns
    2. Troubleshooting the control circuit
    3. Compressor electrical faults
    4. Airside, static pressure and condensate problems
Saved in this browser. Move it to another device →
← Construction, Comfort & Airflow

Chapter 5 · Lesson 4 of 4

Duct leakage, noise, filters and ventilation

1 min read

Duct leaks matter most outside the conditioned space, and the direction of the leak matters too. A return leak in a hot, humid attic pulls attic air straight into the system, adding load and raising indoor humidity. Leaks that stay inside the conditioned space waste far less. Ducts outside the conditioned space are sealed with an approved sealant and insulated.

  • A whistling register means too much air through too little area. Upsize the branch and register; closing the damper just moves the noise and starves the room.
  • MERV rates how well a filter captures particles, not its resistance. Finer filtration usually needs more filter area to keep pressure drop low.
  • An ERV transfers both heat and moisture, so in a humid climate it limits the moisture ventilation air brings in. An HRV transfers heat only.

Example: a customer with a 1-inch filter slot and already-high static pressure wants much finer filtration. Dropping a high-MERV filter into the same slot would cut airflow further. The better plan is a deeper or larger filter cabinet, then measuring static pressure and airflow afterward.

Check yourself

1. Ducts run through a vented attic in a hot, humid climate during the cooling season. Which duct leak does the most damage to indoor humidity?

2. A customer with a one-inch filter slot and an already-high external static pressure asks for much finer filtration. What should the technician explain about moving to a higher MERV filter?

Facts checked 2026-11-15 · Sources: NATE: Certification exams, ACCA Manual J: Residential Load Calculation

NATE HVAC cheat sheet: every key fact on one page →