Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Safety0/4
    1. Lockout, tagout and stored electrical energy
    2. Refrigerant, cylinders and pressure hazards
    3. Carbon monoxide and combustion hazards
    4. PPE, brazing and job-site hazards
  2. 2.Tools & Measurement0/5
    1. Measuring temperature and proving the thermometer
    2. Humidity, wet bulb and dew point
    3. Gauge pressure, absolute pressure and vacuum
    4. Using electrical meters correctly
    5. Airflow, leak detection and charging tools
  3. 3.Basic Electrical0/4
    1. Ohm's law, power and power factor
    2. Series, parallel and reading a ladder diagram
    3. Transformers, single-phase and three-phase power
    4. Single-phase motors, capacitors and winding tests
  4. 4.Science & Refrigeration Cycle0/4
    1. Heat, sensible and latent heat, and heat transfer
    2. Saturation and the four main components
    3. Calculating superheat and subcooling
    4. Metering devices and reading the charge
  5. 5.Construction, Comfort & Airflow0/4
    1. The building envelope: insulation, air sealing and windows
    2. Loads, equipment sizing and comfort
    3. Airflow, static pressure and capacity
    4. Duct leakage, noise, filters and ventilation
  6. 6.AC Components & Operation0/4
    1. Compressors and keeping liquid out
    2. Outdoor coil, indoor coil and condensate
    3. Metering devices, the TXV bulb and charging method
    4. Line sets, accessories, service valves and thermostats
  7. 7.AC Diagnosis & Service0/4
    1. Reading superheat and subcooling patterns
    2. Troubleshooting the control circuit
    3. Compressor electrical faults
    4. Airside, static pressure and condensate problems
Saved in this browser. Move it to another device →
← Safety

Chapter 1 · Lesson 3 of 4

Carbon monoxide and combustion hazards

1 min read

Headache, dizziness, nausea and drowsiness that ease when a person leaves the building are classic signs of carbon monoxide exposure. Carbon monoxide binds to hemoglobin, so the poisoning gets worse the longer people stay inside.

When a technician sees these signs with gas equipment running, the first step is not diagnosis. Get everyone outside, shut the appliance off, and call emergency services or the gas utility.

  • A cracked heat exchanger lets flue gas into the supply air, so the furnace is shut down, locked and tagged, and the owner is told. Sealing the crack is not an accepted repair.
  • A blocked vent connector makes flue gas spill indoors, which is an emergency, not a maintenance item.
  • The appliance stays off until the cause is repaired and proper draft is verified.

Example: on a winter call an occupant says the whole family has had headaches for two days and feels better at work and school. Opening a window and finishing the tune-up is wrong. The safe order is evacuate, shut down, call for help, and only then look for the source, such as a spilling vent or a damaged heat exchanger.

Check yourself

1. An occupant reports headache, dizziness and nausea that ease when she leaves the house, and the gas heating equipment has been running. What should the technician do first?

2. During a service call a technician finds the vent connector on a gas furnace blocked by debris. Why is this treated as an emergency rather than a maintenance item?

Facts checked 2026-11-15 · Sources: NATE: Certification exams, OSHA 29 CFR 1910.147: The control of hazardous energy (lockout/tagout)

NATE HVAC cheat sheet: every key fact on one page →