Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/35 ▾
  1. 1.Ophthalmic Optics0/5
    1. Refractive index and lens power
    2. Surface power and the lens measure
    3. Prism and Prentice's rule
    4. Cylinder power in any meridian
    5. Aberrations, Abbe value and vertex distance
  2. 2.Lens Products & Materials0/5
    1. Choosing a lens material
    2. Coatings, tints and light control
    3. Bifocal and trifocal segments
    4. Progressive lenses
    5. High-power designs and impact testing
  3. 3.Prescription Analysis & Math0/5
    1. Reading and transposing a prescription
    2. Meridian powers and spherical equivalent
    3. Near and intermediate powers from the add
    4. Prism, vertical imbalance and slab-off
    5. Decentration, blank size, vertex and tilt
  4. 4.Frames, Measuring & Fitting0/5
    1. Frame materials and how they behave
    2. Temples, bridges and pads
    3. The boxing system, decentration and blank size
    4. Measuring for multifocals and progressives
    5. Pantoscopic tilt and bench alignment
  5. 5.Instruments & Verification0/5
    1. Setting up and reading a lensmeter
    2. Verifying multifocals and progressives
    3. Verifying prism and centration
    4. The lens clock and other dispensing instruments
    5. Tolerances and final inspection
  6. 6.Laws, Standards & Practice0/5
    1. The FDA impact-resistance rule
    2. The FTC Eyeglass Rule
    3. The FTC Contact Lens Rule
    4. ANSI standards and safety eyewear
    5. Scope of practice, privacy and referral
  7. 7.Ocular Anatomy & Pathology0/5
    1. The front of the eye: cornea, aqueous humor and tear drainage
    2. The crystalline lens: accommodation, aphakia and pseudophakia
    3. The retina, the optic nerve and the visual pathway
    4. Eye diseases an optician must recognize and refer
    5. Visual acuity, astigmatism types and binocular vision
Saved in this browser. Move it to another device →
← Prescription Analysis & Math

Chapter 3 · Lesson 2 of 5

Meridian powers and spherical equivalent

Varies by state. Your state sets this exam: the number of questions, time limit, pass mark and any state-law section can differ from this practice. Check your state's official handbook or licensing board before you test.

1 min read

Draw an optical cross. The sphere power goes on the axis meridian, and sphere plus the full cylinder goes on the meridian 90 degrees away. Those two numbers tell you the type of astigmatism and the power to use for any vertical or horizontal calculation.

Two meridian powersType of astigmatism
Both minusCompound myopic
Both plusCompound hyperopic
One plus, one minusMixed
One plano, one minus or plusSimple myopic or simple hyperopic

Example: −0.50 −1.50 × 090. The 090 meridian carries −0.50 and the 180 meridian carries −0.50 + (−1.50) = −2.00, so both are minus and the eye has compound myopic astigmatism.

The spherical equivalent is the sphere plus half the cylinder: −0.50 + (−0.75) = −1.25 D, the midpoint between the two meridians. Going the other way, if a lens measures +0.50 at 045 and −1.00 at 135, the minus-cylinder form takes the more plus power as the sphere at its own meridian: +0.50 −1.50 × 045.

Between the principal meridians the cylinder builds gradually: none of it acts at the axis, half of it 45 degrees away and all of it 90 degrees away. So plano +2.00 × 180 carries +1.00 in the 045 meridian. The spherical equivalent is also the single power used to approximate a sphero-cylinder, for example when choosing a base curve.

Check yourself

1. What is the spherical equivalent of the prescription -4.75 -2.50 x 015?

2. A distance prescription for the right eye reads +2.00 -3.50 x 090. After determining the power present in each principal meridian, how should this eye's astigmatism be classified?

Facts checked 2026-11-15 · Sources: American Board of Opticianry and National Contact Lens Examiners (ABO-NCLE)

Optician (ABO) cheat sheet: every key fact on one page →