Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/35 ▾
  1. 1.Ophthalmic Optics0/5
    1. Refractive index and lens power
    2. Surface power and the lens measure
    3. Prism and Prentice's rule
    4. Cylinder power in any meridian
    5. Aberrations, Abbe value and vertex distance
  2. 2.Lens Products & Materials0/5
    1. Choosing a lens material
    2. Coatings, tints and light control
    3. Bifocal and trifocal segments
    4. Progressive lenses
    5. High-power designs and impact testing
  3. 3.Prescription Analysis & Math0/5
    1. Reading and transposing a prescription
    2. Meridian powers and spherical equivalent
    3. Near and intermediate powers from the add
    4. Prism, vertical imbalance and slab-off
    5. Decentration, blank size, vertex and tilt
  4. 4.Frames, Measuring & Fitting0/5
    1. Frame materials and how they behave
    2. Temples, bridges and pads
    3. The boxing system, decentration and blank size
    4. Measuring for multifocals and progressives
    5. Pantoscopic tilt and bench alignment
  5. 5.Instruments & Verification0/5
    1. Setting up and reading a lensmeter
    2. Verifying multifocals and progressives
    3. Verifying prism and centration
    4. The lens clock and other dispensing instruments
    5. Tolerances and final inspection
  6. 6.Laws, Standards & Practice0/5
    1. The FDA impact-resistance rule
    2. The FTC Eyeglass Rule
    3. The FTC Contact Lens Rule
    4. ANSI standards and safety eyewear
    5. Scope of practice, privacy and referral
  7. 7.Ocular Anatomy & Pathology0/5
    1. The front of the eye: cornea, aqueous humor and tear drainage
    2. The crystalline lens: accommodation, aphakia and pseudophakia
    3. The retina, the optic nerve and the visual pathway
    4. Eye diseases an optician must recognize and refer
    5. Visual acuity, astigmatism types and binocular vision
Saved in this browser. Move it to another device →
← Ocular Anatomy & Pathology

Chapter 7 · Lesson 1 of 5

The front of the eye: cornea, aqueous humor and tear drainage

Varies by state. Your state sets this exam: the number of questions, time limit, pass mark and any state-law section can differ from this practice. Check your state's official handbook or licensing board before you test.

1 min read

Most of the eye's focusing happens at the cornea, not the lens. Light passes from air into corneal tissue, the largest change in refractive index anywhere in the eye, and the front of the cornea is steeply curved.

Together these give the cornea about 43 D, roughly two-thirds of the eye's total power. That power is fixed. The crystalline lens adds less, but it is the only part that can change its power.

Behind the cornea, two fluids must keep moving. Aqueous humor is produced by the ciliary body in the posterior chamber, flows forward through the pupil into the anterior chamber, and drains at the angle, where the iris meets the cornea, through the trabecular meshwork into Schlemm's canal.

If that outflow is blocked, intraocular pressure rises. That is why the drainage angle is central to glaucoma.

Tears take a completely separate route. They enter the small openings at the inner ends of the lid margins, the puncta, run through the canaliculi to the lacrimal sac, then down the nasolacrimal duct into the nose.

Example: a customer with a blocked nasolacrimal duct complains of constant watering in one eye. Tears are still being made, but they cannot drain, so they spill over the lid.

Check yourself

1. After the ciliary body produces aqueous humor and it flows into the anterior chamber, through which route does it mainly leave the eye?

2. Which structure provides roughly two-thirds of the eye's total refractive power (about 43 D)?

Facts checked 2026-11-16 · Sources: ABO-NCLE Basic Exam Handbook (December 2023), Domain II: Ocular Anatomy, Physiology, Pathology, and Refraction, National Eye Institute: Glaucoma, National Eye Institute: Retinal Detachment

Optician (ABO) cheat sheet: every key fact on one page →