Chapters0/35 ▾
Study guide · Chapter 4 of 7
Frames, Measuring & Fitting Study Guide — Optician (ABO)
Varies by state. Your state sets this exam: the number of questions, time limit, pass mark and any state-law section can differ from this practice. Check your state's official handbook or licensing board before you test.
31 free practice questions
Frame and fitting questions test the hands-on side of dispensing: how each frame material behaves when you heat or repair it, which temple, bridge and pad choices solve a fitting complaint, how the boxing system turns frame numbers into decentration and blank size, and how a frame is aligned on the bench. Many answers come down to one principle, so learn the reason, not just the rule.
Key takeaways
- Acetate is thermoplastic and must be held in its new shape until cool, while epoxy returns toward its molded shape when reheated.
- A rash at the pads and end pieces of a Monel frame points to nickel allergy, and the fix is a titanium or stainless steel frame.
- In the boxing system, frame PD is A plus DBL, and decentration per lens is half the frame PD minus that eye's monocular PD.
- Segment inset per lens is half the difference between the distance and near PDs, and all heights are measured from the lowest point of the lens.
- Lower the optical center about 1 mm for every 2 degrees of pantoscopic tilt, and check temple parallelism with the frame upside down.
Lessons in this chapter
5 short lessons · 5 min read
- 1Frame materials and how they behave1 min
- 2Temples, bridges and pads1 min
- 3The boxing system, decentration and blank size1 min
- 4Measuring for multifocals and progressives1 min
- 5Pantoscopic tilt and bench alignment1 min
Facts checked 2026-11-15 · Sources: American Board of Opticianry and National Contact Lens Examiners (ABO-NCLE), 20/20 Magazine: Martin's rule of tilt, 1 mm of optical center drop per 2 degrees of pantoscopic tilt, ABDO: Mo Jalie on fitting and pantoscopic tilt (PDF), Laramy-K Optical: polycarbonate and Trivex in drill mounts
Optician (ABO) cheat sheet: every key fact on one page →Next chapter: Instruments & Verification →Practice questions based on the American Board of Opticianry Basic Certification exam content outline, standard ophthalmic dispensing references, and the federal rules that govern eyewear (the FDA impact-resistance requirement and the FTC Eyeglass and Contact Lens Rules). ABO and NCLE are marks of the American Board of Opticianry and National Contact Lens Examiners; this site is not affiliated with or endorsed by them. Opticianry is licensed in only some states and the requirements differ — confirm your own state board's practice act and the current exam format before testing. About the ABO exam →