Chapters0/32 ▾
Chapter 2 · Lesson 4 of 4
Water heaters and joining pipe
1 min read
The temperature and pressure relief valve is a storage water heater's last protection against rupture. Its outlet must stay open, with no cap, plug or valve in the discharge line.
A steady drip means the valve is relieving for a reason, such as a setting that is too high, thermal expansion or a fouled seat, and the technician finds and fixes that cause.
- Fill an electric water heater completely and purge air through an open hot faucet before turning power on. An element energized without water around it burns out almost at once.
- Rumbling and popping during heating come from sediment on the tank bottom. Flushing the tank on a schedule removes it, and the anode rod is inspected on the same visit.
- Joining copper to galvanized steel needs a dielectric union, which keeps the two metals apart so galvanic corrosion does not eat the joint.
Example: after replacing an electric water heater, a technician opens the supply valve and a hot faucet, waits until water runs steadily with no spurting air, and only then turns the breaker on. If the relief valve begins to drip later, the technician checks the setting and the cause rather than capping the discharge pipe.
Check yourself
1. A storage water heater's temperature and pressure relief valve is dripping steadily. What is the correct response?
2. A storage water heater rumbles and pops during a heating cycle. What is the MOST likely cause and the correct preventive action?
Facts checked 2026-11-15 · Sources: NAAEI: Certificate for Apartment Maintenance Technicians (CAMT), EPA: Mold and moisture (dry wet materials within 24 to 48 hours)
CAMT Apartment Maintenance cheat sheet: every key fact on one page →