Chapters0/32 ▾
Chapter 2 · Lesson 1 of 4
Supply, distribution and drainage: traps and vents
1 min read
Apartment plumbing is taught as three systems: water supply brings water into the building, water distribution carries hot and cold water to each fixture, and the waste exit system carries used water and waste away. Pressure and temperature complaints belong to the supply side. Smells, slow drains and backups belong to the waste side.
Every fixture trap holds a small plug of water that blocks sewer gas. A vent connected downstream of the trap lets air into the drain so rushing water does not pull a vacuum and siphon the trap dry. Vents move air, not water, and they do not filter gas.
| Symptom | Most likely cause |
|---|---|
| Sewer smell at a fixture that is rarely used | The trap seal evaporated; run water to refill it |
| Slow drain plus gurgling at a nearby fixture | Blocked vent or partial blockage in the shared branch |
| Water rises in a lower fixture when another drains | Blockage downstream of both, in the shared line |
Example: a first-floor kitchen sink backs up each evening when the upstairs dishwasher runs. The water is coming from above, so the clog sits in the shared line below both homes. That is beyond a hand auger at the sink, so it is reported for a plumber or drain contractor.
Check yourself
1. A resident reports a sewer smell near the tub in a guest bathroom that is almost never used. The tub drains normally. What is the MOST likely cause?
2. A resident reports that water rises in the tub whenever the toilet is flushed. Which system does this complaint belong to, and why?
Facts checked 2026-11-15 · Sources: NAAEI: Certificate for Apartment Maintenance Technicians (CAMT), EPA: Mold and moisture (dry wet materials within 24 to 48 hours)
CAMT Apartment Maintenance cheat sheet: every key fact on one page →