Chapters0/32 ▾
Chapter 4 · Lesson 3 of 5
Washers and dryers
1 min read
Laundry calls often trace back to water supply, balance or airflow rather than a failed motor or control. A washer that fills very slowly with the wall valves open and hoses straight usually has clogged screens in its inlet valve.
A washer that bangs and walks during spin after one large comforter was loaded needs the load redistributed and the cabinet leveled. Supply hoses that bulge or feel soft are replaced on sight, because they hold full line pressure around the clock and a burst floods the home and the one below.
Dryer exhaust is a fire question. Lint is the leading fuel in dryer fires, so smooth-wall rigid metal duct is preferred: it traps less lint than ribbed flexible duct and will not burn.
Clothes that need two or three cycles plus a hot cabinet top mean the duct or outside flap is restricted. If the motor runs but the drum does not turn, suspect a broken drive belt.
Before any washer service, close the supply valves. And when a dryer motor runs but the drum does not turn, the drum spins freely by hand with the power off; on models that have a belt switch, a broken belt stops the motor instead.
Check yourself
1. A resident reports that clothes now need two or three cycles to dry and the top of the dryer is hot to the touch. Which finding best explains both symptoms at once?
2. On an electric dryer that has no belt switch, the motor and blower clearly run, but the drum does not turn and the wet clothes stay in place. What is the most likely cause?
Facts checked 2026-11-15 · Sources: NAAEI: Certificate for Apartment Maintenance Technicians (CAMT), EPA: Section 608 of the Clean Air Act (refrigerant management)
CAMT Apartment Maintenance cheat sheet: every key fact on one page →