Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/32 ▾
  1. 1.Electrical Maintenance & Repair0/4
    1. Overloads, short circuits and ground faults
    2. Wiring receptacles, switches and fixtures
    3. Working safely: de-energize, test, then touch
    4. Ohm's law, Watt's law and the multimeter
  2. 2.Plumbing Maintenance & Repair0/4
    1. Supply, distribution and drainage: traps and vents
    2. Shutoffs, leaks and water damage
    3. Toilets, faucets and clearing drains
    4. Water heaters and joining pipe
  3. 3.HVAC Service & When to Refer0/5
    1. Airflow: filters, returns, registers and coils
    2. Condensate drains, pans and float switches
    3. Thermostats and controls
    4. The refrigeration cycle, superheat and EPA Section 608
    5. Furnaces, heat pumps, boilers and gas safety
  4. 4.Appliances, Locks & Keys0/5
    1. Refrigerators: moving heat out of the box
    2. Kitchen appliances: ranges, dishwashers, disposals and hoods
    3. Washers and dryers
    4. Reading schematics and testing parts
    5. Locks, keys and lockouts
  5. 5.Interior & Exterior Repair0/5
    1. Drywall repair
    2. Primer, paint and sheen
    3. Texture and caulk
    4. Doors, windows, cabinets and floors
    5. Exterior, ladders and suspect materials
  6. 6.Compliance, Safety & Fair Housing0/4
    1. Chemicals, PPE and sharps
    2. Lockout/tagout, confined spaces and ladders
    3. Fair housing in maintenance work
    4. Lead, asbestos, mold, pests and records
  7. 7.Facilities Operations & Professionalism0/5
    1. Prioritizing service requests and entering homes
    2. Make-ready turns, inspections and curb appeal
    3. Preventive maintenance, repair or replace, and contractors
    4. Pool and spa chemistry and math
    5. Life safety, reporting and records
Saved in this browser. Move it to another device →
← Back

Study guide · Chapter 4 of 7

Appliances, Locks & Keys Study Guide — CAMT Apartment Maintenance

26 free practice questions

The appliance questions on the CAMT exam cover the refrigerators, ranges, dishwashers, disposals, washers and dryers found in apartment homes, plus lock and key control. Most questions give a symptom and ask for the most likely cause or the first check, and a few ask you to read a wiring schematic or use Ohm's law. The pattern is always the same: rule out the simple, shared causes before condemning an expensive part.

Key takeaways

  • A warm refrigerator with dirty condenser coils gets its coils cleaned before any part is condemned, and a sealed-system repair goes to an EPA 608 certified technician.
  • Check gas connector joints with leak-detector solution and watch for bubbles, never with a flame.
  • Long drying times and a hot dryer cabinet point to a restricted exhaust duct, which is also the main dryer fire risk.
  • When one load fails, test the parts only that load depends on; when everything is dead, test the part everything shares.
  • A lost master key is reported at once so the affected locks can be re-keyed, and keys carry codes, not unit numbers.

Lessons in this chapter

5 short lessons · 5 min read

  1. 1Refrigerators: moving heat out of the box1 min
  2. 2Kitchen appliances: ranges, dishwashers, disposals and hoods1 min
  3. 3Washers and dryers1 min
  4. 4Reading schematics and testing parts1 min
  5. 5Locks, keys and lockouts1 min
View all questions & answers →

Facts checked 2026-11-15 · Sources: NAAEI: Certificate for Apartment Maintenance Technicians (CAMT), EPA: Section 608 of the Clean Air Act (refrigerant management)

CAMT Apartment Maintenance cheat sheet: every key fact on one page →Next chapter: Interior & Exterior Repair →

Practice questions based on the published NAAEI CAMT domains — Essential Trade Skills, Compliance, Facilities Operations, and Professional Development & Collaboration — and on standard trade practice. CAMT and NAAEI are marks of the National Apartment Association; this site is not affiliated with or endorsed by NAA or NAAEI. Code requirements, licensing boundaries and permit rules vary by jurisdiction and revise on a cycle, so none is tested here as a recalled figure — always verify the code having jurisdiction and use a licensed contractor where the work requires one. Confirm current program requirements with NAAEI before testing. About the CAMT credential →