Chapters0/24 ▾
Chapter 4 · Lesson 4 of 4
When a signal person is needed and who has authority
1 min read
Under OSHA 1926.1419 a signal person is required when the point of operation, meaning the load travel path or the area near load placement, is not in full view of the operator; when the view in the direction of travel is obstructed while the crane travels; or when the operator or the person handling the load decides one is needed because of site-specific concerns.
Load weight and the number of cranes on site are not triggers.
- Only one person gives signals at a time. A handoff between signal persons is explicit: they identify each other and the operator acknowledges before movement continues.
- A signal person working more than one crane identifies the crane before giving the function and direction.
- No response is made to a signal that is not clearly understood, and the operator may refuse any move believed unsafe, such as swinging a load over workers.
Signal person qualification under OSHA 1926.1428 comes from either a third-party qualified evaluator or the employer's own qualified evaluator. Only the third-party documentation is portable to a new employer. The documentation is kept available at the site and lists each type of signalling the person is qualified for.
Check yourself
1. A signal person leaves one employer and is hired by another. Which qualification, if any, carries over to the new employer?
2. Under the federal construction crane rule, when is a signal person required for mobile crane work?
Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.1419: Signals, general requirements, OSHA 29 CFR 1926 Subpart CC, Appendix A: Standard hand signals, OSHA 29 CFR 1926.1428: Signal person qualifications
Crane Operator (NCCCO) cheat sheet: every key fact on one page →