Chapters0/24 ▾
Study guide · Chapter 4 of 6
Signals & Communication Study Guide — Crane Operator (NCCCO)
20 free practice questions
Signal questions ask you to read a hand signal, put a voice command in the right order, or decide who may direct the crane and when the operator must stop. The rules come from OSHA 29 CFR 1926.1419 to 1926.1422, the Standard Method chart in Appendix A of Subpart CC, and the signal section of ASME B30.5. Learn the few signals that look alike, and learn the rules about authority, because those carry most of the points.
Key takeaways
- Stop uses one arm swung back and forth palm down, emergency stop uses both arms, and dog everything is both hands together at the waist.
- Anyone may give a stop or emergency stop signal, and the operator must obey it.
- A voice signal series is function and direction, then distance or speed, then function stop, with every direction given from the operator's point of view.
- If communication is lost or a signal is unclear, the operator stops and makes no response until a clear signal is given.
- Only one person signals at a time, and only third-party qualification documentation follows a signal person to a new employer.
Lessons in this chapter
4 short lessons · 4 min read
- 1Stop, emergency stop and dog everything1 min
- 2Hand signals for boom, load, swing and travel1 min
- 3Voice, radio and horn signals1 min
- 4When a signal person is needed and who has authority1 min
Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.1419: Signals, general requirements, OSHA 29 CFR 1926 Subpart CC, Appendix A: Standard hand signals, OSHA 29 CFR 1926.1428: Signal person qualifications
Crane Operator (NCCCO) cheat sheet: every key fact on one page →Next chapter: Operations & Operational Aids →Practice questions based on the published NCCCO mobile crane operator exam outlines and the consensus safety practices the trade runs on. CCO and NCCCO are marks of the National Commission for the Certification of Crane Operators; this site is not affiliated with or endorsed by NCCCO. Capacity always comes from the load chart for the machine and configuration in front of you, and wind, ground-bearing and permit limits are set by the manufacturer's manual and the authority having jurisdiction — never from a practice question. Confirm current exam requirements before testing. About CCO certification →