Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/24 ▾
← Rigging & Load Handling

Chapter 2 · Lesson 4 of 4

Hardware, sling inspection and taglines

1 min read

  • Shackles: use the shackle's own fully seated pin, stay within the marked working load limit, and take multiple legs in the bow, not on the pin. A substitute bolt is never allowed.
  • Hooks: load in the bowl, never on the tip; the latch retains slack slings and carries no load. A bent or twisted hook or an opened throat means removal from service.
  • Eyebolts: an angled pull needs a flush-seated shoulder eyebolt aligned with the pull and derated per the manufacturer, or a swivel hoist ring. Never stack washers to aim the eye.
  • Spreader bars work in compression and lifting beams in bending; both, and all rigging, count as part of the load.

Under OSHA rigging rules, slings are padded or protected from sharp edges, so a softener goes between the sling and a square corner. A wire rope sling with birdcaging or a permanent kink, or any sling whose identification tag is missing or unreadable, comes out of service immediately; it is not straightened, derated or used for light loads.

Taglines are attached before the lift, handled from outside the fall zone, nonconductive near power lines, and never used to pull a hung-up load free.

Check yourself

1. While inspecting a wire rope sling before use, a rigger finds a section where the strands have popped outward into a birdcage, with a permanent kink nearby. What is the correct action?

2. A sling must pass over the square, unprotected corner of a fabricated steel frame. What is the correct action?

Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.251: Rigging equipment for material handling, NCCCO: Mobile Crane Operator certification overview and exam outlines

Crane Operator (NCCCO) cheat sheet: every key fact on one page →