Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/24 ▾
← Site Assessment & Setup

Chapter 3 · Lesson 2 of 4

Outriggers, floats, blocking and level

1 min read

The on-outrigger chart assumes the crane is supported only at the outrigger points, at a specific spread, on a level base. OSHA 1926.1404 and the manufacturer's procedures turn that assumption into setup rules, and the exam asks about each one.

  • Floats, when used, are attached to the outriggers; a loose float can shift or kick out as the corner load changes.
  • Blocking goes under the float, centered so the whole float bears on it, on a level prepared surface, and it must be sound, with no rot or splits. Never block under the outrigger beam, unless the outrigger is designed without a jack, where blocking goes under the outer bearing surface of the beam.
  • Outriggers are fully extended or, if the manufacturer permits, at a specified intermediate position, using the chart for that exact position. Inventing a percentage reduction is not allowed.
  • The outriggers take the crane's weight off the wheels, and each outrigger is in view of the operator or a signal person while it is extended and set.
  • Position sensors must report the real beam position to the rated capacity limiter; a sensor showing full extension on a short beam overstates capacity.

Level matters far more than its small angle suggests. On an out-of-level crane the boom tip drifts downhill, the load hangs farther out than the operator selected, and the boom picks up side load. Level is set within the manufacturer's tolerance and checked again after the machine settles.

Check yourself

1. After setting the outriggers, the operator sees that the tires are still lightly in contact with the ground. What is required?

2. The crane must be set up in a narrow alley where one outrigger cannot be fully extended. What would make that set-up acceptable?

Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.1402: Ground conditions, OSHA 29 CFR 1926.1408: Power line safety (up to 350 kV), equipment operations, OSHA 29 CFR 1926.1404: Assembly/Disassembly, general requirements

Crane Operator (NCCCO) cheat sheet: every key fact on one page →