Chapters0/24 ▾
Chapter 5 · Lesson 4 of 4
Personnel lifts, tandem lifts, wind and shutting down
1 min read
Hoisting people on a suspended platform under OSHA 1926.1431 carries the strictest limits. The total load of platform, occupants, tools and rigging may not exceed 50 percent of the rated capacity for the radius and configuration.
The platform and rigging are proof tested to 125 percent, a trial lift is made before the shift, free fall of the load line is prohibited, and when wind at the platform, sustained or gusting, exceeds 20 mph, a qualified person must decide whether it is safe to lift people; if not, the lift does not begin or is ended.
Example: with a rated capacity of 12,000 lb, the total may not exceed 6,000 lb; a 1,200 lb platform, two workers at 250 lb each and 300 lb of tools total 2,000 lb, which is within the limit.
- Tandem lifts need a plan developed by a qualified person and reviewed with everyone involved, a lift director, and slow, synchronized motions; load sharing is analyzed, one signal person is common, and capacities are often reduced.
- For ordinary lifts, the wind limit comes from the manufacturer for the configuration rigged; the wind indicator shows the wind, not what the crane can stand.
- Before leaving the crane unattended, land the load, position the boom as specified, set brakes and locks, and secure the controls. A suspended load is never left unattended.
Check yourself
1. When a crane is used to hoist employees on a suspended personnel platform, the total load must not exceed what portion of the crane's rated capacity for that radius and configuration?
2. How does the operator determine the wind speed at which a particular lift must be stopped?
Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.1416: Operational aids, OSHA 29 CFR 1926.1431: Hoisting personnel, OSHA 29 CFR 1926.1417: Operation
Crane Operator (NCCCO) cheat sheet: every key fact on one page →