Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/24 ▾
← Operations & Operational Aids

Chapter 5 · Lesson 1 of 4

Operational aids: categories, deadlines and temporary measures

1 min read

A load moment indicator compares the load with the rating for the configuration the operator entered, so it is only as good as that entry and its sensors.

OSHA calls it an operational aid: it supports the operator's own verification and the load chart, and capacity is never found by running into the alarm. When an aid fails, work may continue only under its specific temporary measure, and the repair must be finished by its deadline.

AidCategory and deadlineTemporary measure
Anti two-block deviceI, 7 calendar daysMark the cable; on a telescopic boom, also use a spotter when extending
Load moment indicator or load weighing deviceII, 30 calendar daysDetermine the load weight and give it to the operator before the lift
Boom angle or radius indicatorII, 30 calendar daysPhysically measure the radius or angle
Hoist drum rotation indicatorII, 30 calendar daysMark the drum so rotation is visible

Category I holds only three devices: the boom hoist limiting device, the luffing jib limiting device and the anti two-block device, because each guards against an immediate structural failure or dropped load.

If the employer documents that parts were ordered within 7 days, the repair is due within 7 calendar days after they arrive (for Category II, when they arrive too late to finish within 30 days).

Example: a deficiency found on November 3 is due by November 10 for a Category I aid and by December 3 for a Category II aid. Safety devices such as the crane level indicator are different: operations may not begin unless they work, and there is no grace period.

Check yourself

1. Which device is a Category I operational aid — the group that must be repaired within the shortest time after a deficiency occurs?

2. A mobile crane is equipped with a load moment indicator (LMI). Which statement correctly describes how the operator should use it?

Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.1416: Operational aids, OSHA 29 CFR 1926.1431: Hoisting personnel, OSHA 29 CFR 1926.1417: Operation

Crane Operator (NCCCO) cheat sheet: every key fact on one page →