Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/24 ▾
← Load Charts & Capacity

Chapter 1 · Lesson 3 of 4

Load radius, deflection and the configuration the chart assumes

1 min read

Load radius is the horizontal distance from the crane's axis of rotation to the center of the loaded hoist line. It is not measured along the boom and not from the outrigger floats.

Radius governs capacity; the boom angle indicator only suggests radius. If the angle reading implies 30 ft but a tape on the ground shows 34 ft, you enter the chart at 34 ft.

Every boom deflects when it takes the load: the tip drops and moves out, and the load follows it to a longer radius. So you set up the empty boom at a slightly shorter radius than the chart line needs, then check the radius again with the load just off the ground.

  • Working areas: over the side is generally the least stable on outriggers, and the lowest rating anywhere along the swing path governs.
  • On-rubber ratings are much lower because tires give a narrow, flexing base, and those pages carry their own conditions.
  • Outrigger charts apply only when every beam is at the same listed position; a mixed setup matches no chart.
  • A footnote requiring a minimum counterweight means you use the chart for the counterweight actually installed.

Check yourself

1. A crane is set on outriggers and its chart identifies rated working areas. Which working area is generally the least stable, and what does that mean for a swing?

2. The boom angle indicator suggests the load is at a 30 ft radius, but the radius measured on the ground from the centerline of rotation to the center of gravity of the load is 34 ft. Which value should be used to enter the load chart, and why?

Facts checked 2026-11-15 · Sources: NCCCO: Mobile Crane Operator certification overview and exam outlines, OSHA 29 CFR 1926.1417: Operation (cranes and derricks in construction)

Crane Operator (NCCCO) cheat sheet: every key fact on one page →