Chapters0/24 ▾
Chapter 2 · Lesson 2 of 4
Vertical, choker and basket hitches
1 min read
A sling's tag gives its rated load for each hitch, and the hitch changes the number. The vertical (straight) hitch is the baseline.
In a choker, the sling bends sharply where it passes through its own eye and squeezes the load, so published choker ratings run about 75 to 80 percent of vertical, and they drop further when the choke angle is less than about 120 degrees. Hammering a choker down tight damages the sling and restores nothing.
In a basket, the sling passes under the load and both legs return to the hook, so two legs share the weight. With vertical legs, an adequate D/d and a balanced load, the basket is rated at twice the vertical rating.
As the legs spread, that advantage shrinks with the sling angle: about 1.73 times vertical at 60 degrees, 1.41 times at 45 degrees and only 1.0 times at 30 degrees. Example: a sling rated 4,000 lb vertical is worth 8,000 lb in a vertical-leg basket but only about 5,660 lb with legs at 45 degrees.
D/d is the diameter of the object the sling bends around divided by the rope diameter. Bending wire rope around a small pin or a sharp corner lowers D/d and cuts strength at the bend, so the tabulated basket capacity no longer applies.
Check yourself
1. Compared with the same sling's vertical (straight) hitch rating, how is a choker hitch rated?
2. How does bending a wire rope sling around a small-diameter pin or a sharp corner, rather than around a large-diameter object, affect the sling?
Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.251: Rigging equipment for material handling, NCCCO: Mobile Crane Operator certification overview and exam outlines
Crane Operator (NCCCO) cheat sheet: every key fact on one page →