Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/24 ▾
← Rigging & Load Handling

Chapter 2 · Lesson 1 of 4

Sling angles and leg tension

1 min read

On a two-leg bridle, each leg must hold up its share of the weight. When the leg leans over, it has to pull harder along its length to supply that same upward share.

The angle that matters is measured between the leg and the horizontal. Reading it from the vertical is the classic mistake that swaps the 30 degree and 60 degree answers.

Sling angle from horizontalLoad angle factorMeaning
90 degrees (vertical)1.000Each leg carries only its share
60 degrees1.155About 16 percent more tension
45 degrees1.414About 41 percent more tension
30 degrees2.000Each leg carries the whole load weight

Leg tension equals the leg's share times the factor. A second method needs no table: share times sling length divided by vertical height.

Example: a 5,000 lb load on two legs at 60 degrees gives 2,500 x 1.155 = about 2,888 lb per leg. With 12 ft legs and 9 ft of vertical height, a 4,800 lb load gives 2,400 x 12 / 9 = 3,200 lb per leg.

Check yourself

1. A 4,000 lb load is lifted with a two-leg bridle, and each leg is at 30 degrees from horizontal. Approximately how much tension is in each sling leg?

2. A 6,000 lb load is rigged on a two-leg bridle, and each sling is rated 4,000 lb in a vertical hitch. Of the choices below, what is the flattest sling angle from horizontal that still keeps each leg within its rated load?

Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.251: Rigging equipment for material handling, NCCCO: Mobile Crane Operator certification overview and exam outlines

Crane Operator (NCCCO) cheat sheet: every key fact on one page →