Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/24 ▾
← Rigging & Load Handling

Chapter 2 · Lesson 3 of 4

Load weight and center of gravity

1 min read

Every rigging choice depends on a known weight, so the weight is confirmed from shipping papers, markings, drawings or a calculation from dimensions and material. Judging by how the crane sounds once the load is breaking free is not verification.

If the weight cannot be confirmed, stop and get it confirmed. Example: a solid concrete block 5 ft by 3 ft by 2 ft is 30 cubic feet; at about 150 lb per cubic foot it weighs 4,500 lb.

A suspended load always hangs with its center of gravity directly under the hook. If the hook is off to one side when the load lifts off, the load swings or rolls until it gets there, side loading the boom and shock loading the slings. Center the hook over the center of gravity before the pick.

With two vertical pick points, each one carries the weight times the distance from the center of gravity to the other pick point, divided by the span.

Example: a 9,000 lb beam 30 ft long with its center of gravity 10 ft from the left end puts 20 / 30 x 9,000 = 6,000 lb on the left sling and 3,000 lb on the right.

On a rigid four-leg lift, size each sling as if only two legs carry the whole weight, unless the load is flexible or the legs are individually adjusted.

Check yourself

1. A 12,000 lb beam is 24 ft long and is picked at its two ends with vertical sling legs. The beam's center of gravity is 8 ft from the left end. What load does the left sling carry?

2. Before a pick, how should the weight of the load be established?

Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.251: Rigging equipment for material handling, NCCCO: Mobile Crane Operator certification overview and exam outlines

Crane Operator (NCCCO) cheat sheet: every key fact on one page →