Chapters0/24 ▾
Chapter 3 · Lesson 4 of 4
Assembly, disassembly and the swing area
1 min read
Assembly and disassembly are directed by a person who is both competent and qualified, or a competent person assisted by qualified persons. A competent person can spot existing and predictable hazards and has authority to correct them; a qualified person has shown, through training, experience or professional standing, the ability to solve problems in that work.
Holding an operator certification does not by itself make someone the director. The director reviews the procedures before work starts and makes sure each crew member knows the tasks, the hazards and the places to stay out of.
- When pins are removed, boom sections are held stable with blocking, rigging or supports, and no one stands under them unless site limits force it and the director minimizes the exposure.
- The boom hoist brake is tested before it is relied on.
- The accessible swing area of the counterweight is marked with control lines, warning lines or barriers, or with warning signs plus high-visibility markings on the crane where barriers are infeasible.
Before a worker steps behind the counterweight or anywhere out of the operator's view where the rotating upperworks could strike or pinch, the operator is told, and rotation does not start until the operator hears the worker is safe. A swing alarm or a slower swing does not replace that prearranged communication.
Check yourself
1. Who may serve as the assembly/disassembly director for a mobile crane?
2. A worker needs to step behind the counterweight, out of the operator's view, to reach a hose fitting. What must happen before the superstructure rotates?
Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.1402: Ground conditions, OSHA 29 CFR 1926.1408: Power line safety (up to 350 kV), equipment operations, OSHA 29 CFR 1926.1404: Assembly/Disassembly, general requirements
Crane Operator (NCCCO) cheat sheet: every key fact on one page →