Chapters0/24 ▾
Study guide · Chapter 3 of 6
Site Assessment & Setup Study Guide — Crane Operator (NCCCO)
21 free practice questions
Site and setup questions ask whether the crane is standing on ground that can hold it, configured the way its chart assumes, and kept clear of power lines and people. Almost every answer comes from the federal construction crane standard, OSHA 29 CFR 1926 Subpart CC, so this chapter follows its sections on ground conditions, assembly, power lines and swing areas. Actual ground-bearing limits and wind limits come from qualified people and the manufacturer, never from a practice question.
Key takeaways
- The crane may not be assembled or used unless the ground is firm, drained and graded so that, with mats or blocking, the manufacturer's support and level requirements are met.
- Ground bearing pressure equals the imposed load divided by the contact area, so a bigger mat lowers the pressure in direct proportion.
- Outriggers are fully extended or at a manufacturer-approved intermediate position with its own chart, with floats attached and the tires off the ground.
- Near power lines, assembly and operation use 20 feet unless the voltage is known, and travel with no load uses its own smaller table.
- No one goes into the swing area out of the operator's view until the operator has been told, and rotation waits until the worker is safe.
Lessons in this chapter
4 short lessons · 4 min read
- 1Ground conditions and ground bearing pressure1 min
- 2Outriggers, floats, blocking and level1 min
- 3Power line clearance during assembly, operation and travel1 min
- 4Assembly, disassembly and the swing area1 min
Facts checked 2026-11-15 · Sources: OSHA 29 CFR 1926.1402: Ground conditions, OSHA 29 CFR 1926.1408: Power line safety (up to 350 kV), equipment operations, OSHA 29 CFR 1926.1404: Assembly/Disassembly, general requirements
Crane Operator (NCCCO) cheat sheet: every key fact on one page →Next chapter: Signals & Communication →Practice questions based on the published NCCCO mobile crane operator exam outlines and the consensus safety practices the trade runs on. CCO and NCCCO are marks of the National Commission for the Certification of Crane Operators; this site is not affiliated with or endorsed by NCCCO. Capacity always comes from the load chart for the machine and configuration in front of you, and wind, ground-bearing and permit limits are set by the manufacturer's manual and the authority having jurisdiction — never from a practice question. Confirm current exam requirements before testing. About CCO certification →