Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Structure & Foundation0/5
    1. Footings, soil movement and foundation crack patterns
    2. Water below grade and in crawl spaces
    3. Load path, columns and floor framing
    4. Roof framing: rafters, ridges and trusses
    5. Decay and wood-destroying organisms
  2. 2.Roofing, Exterior & Site0/5
    1. Roof coverings: how they keep water out and how they fail
    2. Flashings and roof penetrations
    3. Roof drainage, ice dams and chimney tops
    4. Walls, cladding and windows as drained assemblies
    5. Decks, grading and retaining walls
  3. 3.Electrical Systems0/5
    1. Service entrance and capacity
    2. Grounding, bonding and the neutral
    3. Inside the panel: overcurrent protection and terminations
    4. Ground-fault, arc-fault and receptacle testing
    5. Older wiring, workmanship defects and generators
  4. 4.Plumbing Systems0/4
    1. Water supply and piping materials
    2. Traps, vents and drain defects
    3. Water heaters, relief valves and gas connections
    4. Cross-connections, backflow and fixture leaks
  5. 5.HVAC, Insulation & Ventilation0/5
    1. Furnace combustion safety
    2. Venting, draft and house depressurization
    3. Boilers, heat pumps and air conditioning
    4. Insulation, air barriers and vapor retarders
    5. Attic ventilation, crawl spaces and exhaust ducts
  6. 6.Standards, Ethics & Reporting0/5
    1. What a home inspection is and is not
    2. Material defects and how to classify findings
    3. Writing the report: methods, limits and wording
    4. Exclusions, environmental hazards and immediate dangers
    5. Agreements, confidentiality and conflicts of interest
Saved in this browser. Move it to another device →
← Structure & Foundation

Chapter 1 · Lesson 2 of 5

Water below grade and in crawl spaces

1 min read

Two below-grade wall treatments are defined by the load they resist. Dampproofing is a coating that slows capillary and vapor moisture where no water stands against the wall.

Waterproofing is a continuous membrane meant to hold back liquid water under pressure, which is what a high water table calls for, together with working perimeter drainage. A heavier coat of dampproofing is not waterproofing.

When an exam question shows staining on one basement wall only, look outside that same wall. A downspout dumping at the foundation and soil sloping toward the house are the usual source, and fixing them is the first and least invasive recommendation.

Interior drains, sealer paint and underpinning treat symptoms or unrelated problems and come later, if at all. For example, if only the north wall is damp and its downspout ends at the wall, the report links the two and recommends extending the discharge and regrading first.

Crawl spaces follow dew-point logic. In a hot, humid climate, outdoor air entering a vented crawl space cools on ducts and the underside of the floor, reaches its dew point and leaves liquid water and mold.

That is why the problem is worst in summer and dry in winter, and why adding more vents makes it worse. The direction of correction is ground moisture control and a sealed, conditioned or dehumidified crawl space.

Check yourself

1. A basement shows staining and efflorescence along the wall-to-floor cove joint on one side of the house only. Outside that same wall, a downspout discharges directly at the foundation and the grade slopes back toward the house. What should the inspector recommend first?

2. In a hot, humid climate an inspector finds a vented crawl space with condensation and surface mold on cool duct surfaces and on the underside of the floor during summer, while the same crawl space is dry in winter. What is the most likely mechanism?

Facts checked 2026-11-15 · Sources: National Home Inspector Examination (EBPHI), InterNACHI Home Inspection Standards of Practice

Home Inspector Practice Test (NHIE) cheat sheet: every key fact on one page →