Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Structure & Foundation0/5
    1. Footings, soil movement and foundation crack patterns
    2. Water below grade and in crawl spaces
    3. Load path, columns and floor framing
    4. Roof framing: rafters, ridges and trusses
    5. Decay and wood-destroying organisms
  2. 2.Roofing, Exterior & Site0/5
    1. Roof coverings: how they keep water out and how they fail
    2. Flashings and roof penetrations
    3. Roof drainage, ice dams and chimney tops
    4. Walls, cladding and windows as drained assemblies
    5. Decks, grading and retaining walls
  3. 3.Electrical Systems0/5
    1. Service entrance and capacity
    2. Grounding, bonding and the neutral
    3. Inside the panel: overcurrent protection and terminations
    4. Ground-fault, arc-fault and receptacle testing
    5. Older wiring, workmanship defects and generators
  4. 4.Plumbing Systems0/4
    1. Water supply and piping materials
    2. Traps, vents and drain defects
    3. Water heaters, relief valves and gas connections
    4. Cross-connections, backflow and fixture leaks
  5. 5.HVAC, Insulation & Ventilation0/5
    1. Furnace combustion safety
    2. Venting, draft and house depressurization
    3. Boilers, heat pumps and air conditioning
    4. Insulation, air barriers and vapor retarders
    5. Attic ventilation, crawl spaces and exhaust ducts
  6. 6.Standards, Ethics & Reporting0/5
    1. What a home inspection is and is not
    2. Material defects and how to classify findings
    3. Writing the report: methods, limits and wording
    4. Exclusions, environmental hazards and immediate dangers
    5. Agreements, confidentiality and conflicts of interest
Saved in this browser. Move it to another device →
← Standards, Ethics & Reporting

Chapter 6 · Lesson 4 of 5

Exclusions, environmental hazards and immediate dangers

1 min read

Identifying wood-destroying organisms and testing for radon, mold, lead paint or asbestos are excluded from a general home inspection unless the parties separately agree, because they need specialized licensing, sampling or lab analysis. Knowing the federal reference points still helps you advise a client.

EPA recommends fixing a home when radon is 4 pCi/L or more, and says to consider fixing between 2 and 4 pCi/L. Example: a separately ordered radon test that reads 3.1 pCi/L is below 4 but inside the range where EPA says to consider fixing.

EPA also notes that homes built before 1978 are more likely to contain lead-based paint, which is a hazard mainly when it deteriorates or is disturbed.

A life-threatening condition changes how the finding is delivered. If the inspector smells gas and a detector responds strongly at a furnace union, the client and occupants are told at once and the finding is placed conspicuously in the report, not buried in the heating section.

The inspector does not tighten the union or shut the gas at the meter; correction belongs to the gas utility or a qualified professional.

If the client wants one of these services, the inspector refers them to a qualified specialist or, if properly qualified, adds it to the written agreement as a separate service with its own scope.

Check yourself

1. At the furnace the inspector smells gas and a combustible-gas detector responds strongly near the union at the appliance connection. What is the appropriate action?

2. Which of the following falls outside the scope of a general home inspection unless the parties separately agree to include it?

Facts checked 2026-11-15 · Sources: InterNACHI Home Inspection Standards of Practice, InterNACHI Code of Ethics for Home Inspectors, ASHI Standard of Practice for Home Inspection, EPA: Health Risk of Radon, EPA: Protect Your Family from Sources of Lead

Home Inspector Practice Test (NHIE) cheat sheet: every key fact on one page →