Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Structure & Foundation0/5
    1. Footings, soil movement and foundation crack patterns
    2. Water below grade and in crawl spaces
    3. Load path, columns and floor framing
    4. Roof framing: rafters, ridges and trusses
    5. Decay and wood-destroying organisms
  2. 2.Roofing, Exterior & Site0/5
    1. Roof coverings: how they keep water out and how they fail
    2. Flashings and roof penetrations
    3. Roof drainage, ice dams and chimney tops
    4. Walls, cladding and windows as drained assemblies
    5. Decks, grading and retaining walls
  3. 3.Electrical Systems0/5
    1. Service entrance and capacity
    2. Grounding, bonding and the neutral
    3. Inside the panel: overcurrent protection and terminations
    4. Ground-fault, arc-fault and receptacle testing
    5. Older wiring, workmanship defects and generators
  4. 4.Plumbing Systems0/4
    1. Water supply and piping materials
    2. Traps, vents and drain defects
    3. Water heaters, relief valves and gas connections
    4. Cross-connections, backflow and fixture leaks
  5. 5.HVAC, Insulation & Ventilation0/5
    1. Furnace combustion safety
    2. Venting, draft and house depressurization
    3. Boilers, heat pumps and air conditioning
    4. Insulation, air barriers and vapor retarders
    5. Attic ventilation, crawl spaces and exhaust ducts
  6. 6.Standards, Ethics & Reporting0/5
    1. What a home inspection is and is not
    2. Material defects and how to classify findings
    3. Writing the report: methods, limits and wording
    4. Exclusions, environmental hazards and immediate dangers
    5. Agreements, confidentiality and conflicts of interest
Saved in this browser. Move it to another device →
← Standards, Ethics & Reporting

Chapter 6 · Lesson 2 of 5

Material defects and how to classify findings

1 min read

A material defect is defined by two objective tests: it may have a significant adverse impact on the value of the property, or it poses an unreasonable risk to people.

Repair cost, how visible it is to a buyer, and the inspector's personal sense of seriousness are not the test. Reaching or passing a typical service life is not a defect by itself.

FindingClassification
22-year-old furnace that runs normally with no warning signsReport its age and condition; not a defect on age alone
Leaf-packed gutter and downspout at the foundationMaintenance item, reportable because of its implication for the foundation
Scuffed, faded interior doorCosmetic

The standards also stop short of remaining-life predictions. A one-time visual look cannot see future use, maintenance or hidden internal wear, so a stated number of years would work as an unsupported guarantee. Typical service-life data can inform the conversation, but it does not become a promise in the report.

Sorting findings is the tested skill. Ask two questions about each one: could it significantly affect value, and could it hurt someone?

A maintenance item is still reportable when its consequence matters, such as roof water delivered to the foundation, while cosmetic wear that fails both tests is not a material defect. This keeps the same condition from being reportable in one report and ignored in another.

Check yourself

1. What makes an observed condition a 'material defect' rather than an ordinary observation?

2. An inspector finds gutters packed with leaves and a downspout discharging directly against the foundation wall, and separately notes a scuffed, faded interior door. How should these two findings be characterized?

Facts checked 2026-11-15 · Sources: InterNACHI Home Inspection Standards of Practice, InterNACHI Code of Ethics for Home Inspectors, ASHI Standard of Practice for Home Inspection, EPA: Health Risk of Radon, EPA: Protect Your Family from Sources of Lead

Home Inspector Practice Test (NHIE) cheat sheet: every key fact on one page →