Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Structure & Foundation0/5
    1. Footings, soil movement and foundation crack patterns
    2. Water below grade and in crawl spaces
    3. Load path, columns and floor framing
    4. Roof framing: rafters, ridges and trusses
    5. Decay and wood-destroying organisms
  2. 2.Roofing, Exterior & Site0/5
    1. Roof coverings: how they keep water out and how they fail
    2. Flashings and roof penetrations
    3. Roof drainage, ice dams and chimney tops
    4. Walls, cladding and windows as drained assemblies
    5. Decks, grading and retaining walls
  3. 3.Electrical Systems0/5
    1. Service entrance and capacity
    2. Grounding, bonding and the neutral
    3. Inside the panel: overcurrent protection and terminations
    4. Ground-fault, arc-fault and receptacle testing
    5. Older wiring, workmanship defects and generators
  4. 4.Plumbing Systems0/4
    1. Water supply and piping materials
    2. Traps, vents and drain defects
    3. Water heaters, relief valves and gas connections
    4. Cross-connections, backflow and fixture leaks
  5. 5.HVAC, Insulation & Ventilation0/5
    1. Furnace combustion safety
    2. Venting, draft and house depressurization
    3. Boilers, heat pumps and air conditioning
    4. Insulation, air barriers and vapor retarders
    5. Attic ventilation, crawl spaces and exhaust ducts
  6. 6.Standards, Ethics & Reporting0/5
    1. What a home inspection is and is not
    2. Material defects and how to classify findings
    3. Writing the report: methods, limits and wording
    4. Exclusions, environmental hazards and immediate dangers
    5. Agreements, confidentiality and conflicts of interest
Saved in this browser. Move it to another device →
← Structure & Foundation

Chapter 1 · Lesson 1 of 5

Footings, soil movement and foundation crack patterns

1 min read

A footing is wider than the wall it carries for one reason: to spread the load over more soil so the bearing pressure stays below what the soil can hold. That is why footings belong on undisturbed native soil or engineered fill, not on loose backfill or topsoil.

Example: a wall that puts 2,000 pounds on each foot of length, resting on a footing 16 inches wide, presses on the soil at about 1,500 pounds per square foot; widen the footing to 24 inches and the pressure drops to 1,000.

What you seeMost likely mechanism
Horizontal crack near mid-height of a block wall, upper part pushed inwardLateral soil pressure, often worse when the backfill is saturated
Stair-step crack at a corner, wider at the top, with a sloping floorDifferential settlement of that corner
Fine, even-width vertical cracks with no offset in a new concrete wallCuring shrinkage; describe and recommend monitoring
Cracks that open in dry spells and close after wet seasonsExpansive clay shrinking and swelling

Frost heave is a cold-climate mechanism: water in the soil freezes, expands and lifts anything bearing within the freezing zone, so shallow piers move every winter. White powdery efflorescence shows that water has passed through masonry and evaporated; it is evidence of moisture, not of structural damage or mold.

Check yourself

1. In a basement with concrete block foundation walls, an inspector observes a continuous horizontal crack along a mortar joint near mid-height of one wall, with the courses above the crack displaced inward relative to the courses below. What does this pattern most strongly indicate?

2. An inspector finds stair-step cracking through the mortar joints at one exterior corner of a masonry foundation, wider at the top than at the bottom, together with an out-of-square door frame and a floor that slopes toward that same corner. This pattern most strongly suggests which condition?

Facts checked 2026-11-15 · Sources: National Home Inspector Examination (EBPHI), InterNACHI Home Inspection Standards of Practice

Home Inspector Practice Test (NHIE) cheat sheet: every key fact on one page →