Chapters0/29 ▾
Chapter 5 · Lesson 2 of 5
Venting, draft and house depressurization
1 min read
An atmospherically vented appliance depends on hot, buoyant flue gas warming the flue and rising. That draft is weak, so it is the first thing in the house to fail. Two common causes appear on the exam.
First, the orphaned water heater: a condensing furnace is vented out the side wall with plastic pipe, leaving a small water heater alone on a masonry chimney sized for both.
The flue is now too big and too cold, the gases cool and stall, and the heater spills. Second, exhaust depressurization: a large range hood and bath fans pull more air out than the shell can replace, and the open flue becomes the easiest inlet, so the draft reverses.
Duct leakage and attic fans add to the same picture. Supply leaks outside the thermal envelope deliver conditioned air to the attic, return leaks pull attic air in, and unequal leakage shifts house pressure.
A powered attic ventilator next to a ridge vent short-circuits the eave-to-ridge path and pulls conditioned air through ceiling gaps, and the extra depressurization can disturb appliance draft. That turns energy comments into safety comments.
The exam often hides this mechanism inside a renovation: a new furnace, a new range hood or a new attic fan. Whenever one change touches a shared vent or house pressure, ask whether a nearby atmospheric appliance can still draft, and report spillage as a carbon monoxide hazard needing prompt evaluation.
Check yourself
1. After a kitchen renovation added a high-capacity ducted range hood, the homeowner reports a sooty smell, and the inspector observes flue gases spilling from the draft hood of the atmospherically vented gas water heater whenever the hood runs on high with the bathroom fans on. What best explains this?
2. A high-efficiency condensing furnace has been installed and vented with plastic pipe through the rim joist, and it drains acidic condensate to a floor drain. The gas water heater that formerly shared the masonry chimney with the old furnace is now the only appliance connected to that flue, and spillage is detected at its draft hood several minutes after the burner fires. What best explains the spillage?
Facts checked 2026-11-15 · Sources: National Home Inspector Examination (EBPHI), InterNACHI Home Inspection Standards of Practice
Home Inspector Practice Test (NHIE) cheat sheet: every key fact on one page →