Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
← Plumbing Systems

Chapter 4 · Lesson 4 of 4

Cross-connections, backflow and fixture leaks

1 min read

A cross-connection is any arrangement that could let non-potable water into the drinking-water supply. A garden hose on a laundry-tub faucet with its end lying in the tub is a submerged outlet below the flood rim; if supply pressure drops, tub water can be siphoned back.

The basic protection is an air gap above the rim, or a vacuum breaker where an air gap is not practical.

Backflow typeCauseExample
Back-siphonageNegative or reduced pressure on the supply sideHose submerged in a tub
BackpressureDownstream pressure higher than supply pressureBoiler make-up water line; needs a listed backflow preventer, not just a check valve

Fixture leaks are traced from evidence to cause without opening anything. A toilet that rocks, with odor and stained flooring at its base, points to a failed seal and possibly a damaged flange or subfloor; the extent cannot be judged without removing the fixture.

A stained ceiling under a bathroom with cracked shower grout and missing tub sealant is reported as a likely water path, with evaluation and repair recommended. Opening the ceiling or flood-testing the shower pan is outside a visual inspection.

Check yourself

1. A boiler make-up water line is connected to the potable water supply, and the boiler can operate at a pressure higher than the pressure in the house supply piping. Which statement best describes the hazard?

2. A garden hose is attached to the laundry-tub faucet and its free end lies in the bottom of the tub. Why is this a cross-connection, and what is the basic protection?

Facts checked 2026-11-15 · Sources: National Home Inspector Examination (EBPHI), InterNACHI Home Inspection Standards of Practice

Home Inspector Practice Test (NHIE) cheat sheet: every key fact on one page →