Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/29 ▾
  1. 1.Structure & Foundation0/5
    1. Footings, soil movement and foundation crack patterns
    2. Water below grade and in crawl spaces
    3. Load path, columns and floor framing
    4. Roof framing: rafters, ridges and trusses
    5. Decay and wood-destroying organisms
  2. 2.Roofing, Exterior & Site0/5
    1. Roof coverings: how they keep water out and how they fail
    2. Flashings and roof penetrations
    3. Roof drainage, ice dams and chimney tops
    4. Walls, cladding and windows as drained assemblies
    5. Decks, grading and retaining walls
  3. 3.Electrical Systems0/5
    1. Service entrance and capacity
    2. Grounding, bonding and the neutral
    3. Inside the panel: overcurrent protection and terminations
    4. Ground-fault, arc-fault and receptacle testing
    5. Older wiring, workmanship defects and generators
  4. 4.Plumbing Systems0/4
    1. Water supply and piping materials
    2. Traps, vents and drain defects
    3. Water heaters, relief valves and gas connections
    4. Cross-connections, backflow and fixture leaks
  5. 5.HVAC, Insulation & Ventilation0/5
    1. Furnace combustion safety
    2. Venting, draft and house depressurization
    3. Boilers, heat pumps and air conditioning
    4. Insulation, air barriers and vapor retarders
    5. Attic ventilation, crawl spaces and exhaust ducts
  6. 6.Standards, Ethics & Reporting0/5
    1. What a home inspection is and is not
    2. Material defects and how to classify findings
    3. Writing the report: methods, limits and wording
    4. Exclusions, environmental hazards and immediate dangers
    5. Agreements, confidentiality and conflicts of interest
Saved in this browser. Move it to another device →
← Electrical Systems

Chapter 3 · Lesson 4 of 5

Ground-fault, arc-fault and receptacle testing

1 min read

A ground-fault circuit interrupter compares current going out on the hot conductor with current coming back on the neutral and opens on a very small imbalance, a people-protection threshold far below any breaker trip.

An arc-fault device instead watches the waveform for the erratic signature of arcing at damaged cable or loose terminals, a fire condition that creates no imbalance at all. They see different events, so arc-fault protection in bedrooms does not replace ground-fault protection in a bathroom.

Because it only compares the two circuit conductors, a ground-fault receptacle works on an old two-wire circuit with no equipment ground. It does not create a ground for whatever is plugged in, so it must be labeled to disclose that. On such circuits the acceptable fixes are a real equipment ground, a non-grounding receptacle, or ground-fault protection with labels.

A three-light tester that reads correct on an ungrounded circuit may be fooled by a bootleg jumper from neutral to ground, which ties appliance cases to a current-carrying conductor. Reversed polarity at a lampholder energizes the screw shell, the part people touch when changing a bulb.

Check yourself

1. A three-slot receptacle in an older house reads "correct" on a three-light plug-in tester, but the inspector suspects the branch circuit has no equipment grounding conductor. What does this combination most likely indicate, and why does it matter?

2. A client asks whether the arc-fault protection in the bedrooms makes the ground-fault protection in the bathroom unnecessary. What is the correct explanation of the two protective functions?

Facts checked 2026-11-15 · Sources: National Home Inspector Examination (EBPHI), InterNACHI Home Inspection Standards of Practice

Home Inspector Practice Test (NHIE) cheat sheet: every key fact on one page →