Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/23 ▾
← Regulations, Records & Publications

Chapter 1 · Lesson 4 of 5

Keeping records, AD status and inspection timing

1 min read

Section 91.417 splits aircraft records into two groups. Records of ordinary maintenance, preventive maintenance, alterations and inspections are kept until the work is repeated or superseded, or for one year after it was done.

Permanent records travel with the aircraft when it is sold: total time in service, status of life-limited parts, time since last overhaul, current inspection status, airworthiness directive status and major alteration forms.

For each AD the record shows the method of compliance, the AD number and revision date, and, for recurring action, the time and date the next action is due.

Only the engine manufacturer, or an agency it approves, may rebuild an engine and issue a new record with no previous operating history (91.421). An overhaul, however thorough, does not reset the time.

Example of the 10-hour allowance in 91.409(b): a rental airplane's 100-hour inspection comes due at 960.0 hours, and it is flown to the shop and inspected at 967.5 hours. The next inspection is due at 1,060.0 hours, which is only 92.5 hours later, because the 7.5 hours flown over are charged to the new interval.

How the exam asks: it names one piece of work, such as a brake change, and asks how long to keep the record. A brake change is ordinary maintenance, so the answer is until it is repeated or superseded, or one year, not permanently.

Check yourself

1. An airplane used for flight instruction for hire had its last 100-hour inspection at 1,240.0 hours time in service. Using the en route allowance of 14 CFR 91.409(b), it reached the shop at 1,344.0 hours and was inspected there. When is the next 100-hour inspection due?

2. A mechanic replaces a brake assembly on a part 91 airplane. Under 14 CFR 91.417, how long must the record of that work be kept?

Facts checked 2026-11-15 · Sources: FAA-S-ACS-1 Aviation Mechanic Airman Certification Standards, 14 CFR Part 43: Maintenance, Preventive Maintenance, Rebuilding, and Alteration, 14 CFR Part 65: Certification: Airmen Other Than Flight Crewmembers

FAA A&P Mechanic (General) cheat sheet: every key fact on one page →